Epson Stylus C41 Service Manual page 31

Stylus C41/42/43/44 series
Figure 2-32. Removing the Printhead unit
9. Disconnect the FFC from the connector.
Figure 2-33. Disconnecting the FFC
Disassembly and Assembly
Printhead unit
FFC
Disassembly
T
If the Carriage unit is disassembled or replaced with a new one,
make sure that the Carriage timing belt is set in the assembling
groove correctly as following figure.
A D J U S T M E N T
When the Printhead is replaced with a new one, following adjustments
R E Q U I R E D
must be performed in the order below: Refer to Table 3-1.
1. Initial ink charge
2. Head ID input
3. Bi-D adjustment
When the Printhead is removed and reinstalled, only the following
adjustment is required. Refer to Table 3-1.
1. Head cleaning
2. Bi-D adjustment
Revision B
Timing belt
31