GE JP989 Series Technical Service Manual page 9

Remove and replace the filter diagonally through the
vent opening.
When replacing the filter, make
sure it rests, at an angle, on the
supports in the vent opening.
Latch it in place.
GEA00189
Molded flat area
Flat
be left until the surface of the cooktop has cooled.
Do not continue to use the soiled surface unit until all
of the spillage has been removed. Follow the steps
under Heavy, Burned-On Soil to continue the
cleaning process.
Caution: If pots with a thin overlay of aluminum, copper,
or enamel are allowed to boil dry, the overlay may bond
with the glass cooktop and leave a black discoloration.
This should be removed immediately before heating
again or the discoloration may be permanent.
Vent System
Vent Filter
WARNING: Before cleaning the vent grille, be sure the
Vent
Chamber
exhaust blower is turned off.
To clean the vent grille, remove it from the cooktop by
lifting it up and off. Wipe the vent grill with a damp cloth.
If necessary, the vent grille can be washed in the sink.
Use dishwashing liquid for cleaning. Do not use abrasive
cleaners, they will damage the vent grille's finish.
GEA00190
Do not clean the vent grille in the dishwasher.
To clean the vent chamber, use hot, soapy water. Do
not use abrasive cleaners, they will damage the vent
chamber's finish.
Vent Filter
Caution: Do not operate the vent without the filter in
place.
The filter is held in place with a metal latch. Move the
latch up in either direction and lift the filter diagonally up
and out of the vent opening.
Clean the filter by swishing it in hot, soapy water. Rinse
well and dry thoroughly.
To order filters, please call our toll-free number:
National Parts Center.............................. 800-626-2002
Filter ...................................................... # WB02X10651
Control Knobs
The control knobs may be removed for easier cleaning.
Before removing the knobs for cleaning, be sure they are
in the OFF position. When replacing the knobs, check
the OFF position to insure proper placement.
Wash knobs in soap and water, but do not soak them.
GEA00191
Avoid getting water into the knob stem holes.
The knob stem is flat on one side (see illustration).
Check the inside of the knob and find the molded flat
area.
Replace the knob by fitting the molded flat area inside
the knob onto the flat area of the stem.
– 7 –