Advertisement
ASSEMBLY FOR WATER FILTRATION FUNCTION
• Unlock the locking latches pulling outwards
as shown in the figure.
• Put the motor bonnet away through holding
it from carrying handle.
•Put water filter exhaust inside the tank as
shown in the figure by pushing through the
suction mouth.
• Fill the tank with water by respecting the
exact amount of water indicated on the tank
as "MAX. WATER LEVEL" . (3,5 lt.)
NOTE: The level of the water should be
same as the level indicated on the product
with MAX. WATER LEVEL .
• Put the inner bonnet into the tank as shown
in the figure.
• Put the motor bonnet back on the tank
through holding it from carrying handle and
lock the latches by pushing right and left.
NOTE: Do not operate your machine
without water when using water filtration
function.
WARNING: Detergent residual, from
handy cleaning of the carpets and
parquetries causes foaming in the tank.
In that case immediately switch off the
machine and change the water in the
tank, otherwise your motor will be
damaged by foams.
Advertisement
