Installation; Connecting With An Nvr; Connecting With A Dvr - CBC DDK-1000 Installation & Operation Manual

3. INSTALLATION

Please follow the instructions and the diagram below to set up the system.
NOTE: The Ipxcam is linked by its Video Out connection via a BNC connector to a monitor's
Video In connection. If this connection is there, you can see some information on the
monitor screen, such as the Ipxcam factory default Static IP address(192.168.1.168).
But the Ipxcam Static IP address can only appear if there is a connection between the
Ipxcam and another device. If there is no such connection, the Ipxcam factory default
Static IP address will not appear on the monitor screen.

3.1 CONNECTING WITH AN NVR

Use a straight LAN cable to connect directly to an NVR.

3.2 CONNECTING WITH A DVR

VIDEO
MUX'S VCR IN
CONNECT TO ETHERNET
RJ45 CONNECTOR
CONNECT TO NVR
ETHERNET PORT
VIDEO AUDIO
ETHERNET
OUT
OUT
CONNECT TO VIDEO OUT
BNC CONNECTOR
CONNECT TO DVR
VIDEO IN
FROM MUX
MAIN MONITOR
AUDIO
IN
IN
ETHERNET
OUT
OUT
TO
TO
MONITOR
LAN CAMERA
SD Card
RS-485
RS-232
10/100
ALARM I/O
LAN CAMERA
SD Card
RS-485
RS-232
10/100
ALARM I/O
11
DC12V
DC12V