Kodak 2400DSV-E Operator's Manual page 21

A-61316 September 2004
2 Lamp Illuminance (Centering/Fit key) - adjusts the illumination of the
screen. To adjust:
•
Hold down the Shift key while pressing the Centering/Fit key until
the desired contrast is achieved. When this key is continuously
pressed, the screen is gradually darkened until it is turned off.
When the screen is turned off, you can press any key to illuminate
the screen to the maximum level.
3 Resolution - sets the resolution of the scanner.
•
When the scanner is connected to the printer. Available
resolutions are: 400 dpi (4H) and 600 dpi (6H)
•
When the scanner is connected to the PC through PowerFilm
Application software. Available resolutions are: 200, 300, 400, 600
and 800 dpi (2H, 3H, 4H, 6H and 8H respectively).
4 Job Recall - when this key is pressed together with the Shift key, the
program registration locations (IJ, 2J and 3J) are called. Each time
this key is pressed while the Shift key is held down, the display
rotates through 1J, 2J and 3J.
5 Zoom - sets zoom magnification.
•
Zoom+: when Zoom+ is pressed with the Shift key the
magnification is increased by an increment of 0.0IX (up to 2.00X).
•
Zoom clr: clears the current zoom setting when this key is held
down together with the Shift key for one second.
•
Zoom-: when Zoom- is pressed with the Shift key the
magnification is decreased by a decrement of 0.01X (down to
0.50X).
6 Shift - the Shift key must be pressed when you want to access one of
the functions described in this section: Lamp Illumination, Resolution,
Job Recall, Zoom or PC/PR.
7 PC/PR - when selected (with the Shift key) the connection to the PC
or printer is selected. This key is not valid unless the PC interface
cable is connected to the PC.
2-7