Cisco DVR Configuration Manual page 22

Chapter 2 Customizing DVR Services
DVR Behavior
First Runs
Recording Option
(_FRDA SAM
service)
Power Save Feature
Screen-Saver Logo
(ssmsologo.rle)
14
Default Behavior
From the All Episode Recording
Options screen, subscribers can
record all episodes (first-run and
rerun episodes) by selecting any of
the following options from the All
Episode Recording Options screen:
On this channel at any time

On this channel, this day, and in

this time slot
On this channel, any day, and in

this time slot
By default, the Power Save feature is
enabled for DVR service. When this
feature is enabled, a DVR spins
down the hard disk drive and
activates a screen saver after any 15
minute period of inactivity that
occurs between 1 a.m. and 6 a.m.
When in spin-down mode, DVRs
display a black screen with the
message Press any remote key to
continue watching TV. This
message moves every 10 seconds to
prevent screen burn in.
Subscriber Impact
Custom Behavior
When customized, the First Run only
on this channel option is added to the
All Episode Recording Options screen,
as shown in the following example.
Selecting this option allows
subscribers to record first runs (new
episodes) of a selected program on a
particular channel.
When customized, the Power Save
feature is disabled for a DVR.
To disable the Power Save feature,
contact Cisco Services for assistance.
When enabled, the configured logo
appears above the default message, as
shown in the following example. The
logo and message move every 10
seconds to prevent screen burn in.
Note: To enable this feature, refer to
LogoTool Software User's Guide (part
number 4000820) and Configuring
Logos on the DNCS (part number
738163).
4011411 Rev B