Cisco DVR Configuration Manual page 12

Chapter 1 Enabling DVR Service
6 Follow these instructions to enter data in the Set Up Package window:

Package Name: Enter the package name that your billing system uses to
enable DVR functionality. The name that you enter here must exactly match
the package name that your billing system uses. For example, you might use
the PVRAC package to enable DVR functionality.
Note: If necessary, contact your billing system operator to obtain the correct
package name.

Duration: Leave the default value of Unlimited.
Click Save to save this package in the DNCS database and close the Set Up
7
Package window. The package appears in the Package List window.
8 From the Package List window, select the package you will use to authorize DVR
service. From the Package List window, select the package you will use to
authorize DVR service.
Click File and then select Open. The Set Up Package window opens for the
9
package you selected.
10 Record the number shown in the EID field here: _________________________
Note: The number shown in the EID field is in hexadecimal format.
11 Click Cancel to close the Set Up Package window and return to the Package List
window.
12 Click File and then select Close to close the Package List window and return to
the DNCS Administrative Console.
13 Refer to the hexadecimal conversion table in EID Conversion Table (on page 55)
to convert the EID from hexadecimal format to decimal format, and then write
the decimal format of the EID here: ____________________
14 Go to Adding a DVR Service to the SAM (on page 5).
4 4011411 Rev B