Mira Orbis Installation And User Manual page 19

1.
Switch on the electrical
supply and press the 'Start/
Stop' button
3.
Set to desired position.
5.
Allow 10 - 15 seconds for any temperature adjustments to reach the handset.
6.
Press STOP button, light on the button
goes out. Shower flow will continue for a
few seconds before stopping. Switch off
the electrical supply.
Note!.At the end of every shower make sure that the shower head points into the
catchment area. A small amount of water may be retained in the shower handset
after the shower has been turned off. This may drain over a few minutes.
2.
The temperature indicator
becomes illuminated.
4.
Check water temperature before
entering shower.
7.
Residual water may drain over a
few minutes.
19
Temperature
of Shower
Clock