JVC HX-GX7 Service Manual page 22

3.2.6 Removing the pickup
(See Fig.13 , 14)
• Prior to performing the following procedure, remove the servo
control board and CD tramecha assembly.
(1) From top of the CD tramecha assembly, turn the cam gear
in the direction of the arrow to move the pickup assembly
outward.
(2) Push down the stopper h in the direction of the arrow and
pull out the shaft.
(3) Release the joint i of the pickup assembly and mecha
base.
(4) Remove the screw G attaching the CD rack. Release the
four tabs j at the bottom of the CD rack.
1-22 (No.MB161)
i
Mecha base
Pickup assembly
h
Cam gear
Shaft
Stopper
Fig.13
CD lack
j
j
j
Fig.14
Shaft
Shaft
Stopper
G
Pickup