Page 1
DAB & FM Radio With Clock, Alarm & Snooze Functions Now you have purchased a MAXTEK® product you can rest assured in the knowledge that as well as your 3 year parts and labour warranty you have the added peace of...
Page 2
Contents 1. Contents 2. Welcome Section 3. General Information and Safety Instructions 4. Controls 5. Instructions 6. Warranty Card...
, supported by the high quality standards of Quesh. We want you to be completely satisfied with your purchase so this MAXTEK® product is backed by a comprehensive manufacturer’s 3 year warranty and an outstanding after sales service through our dedicated helpline.
General Information and Safety Instructions This DAB radio can be powered by 6 x AA batteries. Do not dispose of batteries in your household waste. Please contact your local authority for details on safe disposal. • Never throw batteries into a fire or expose to excessive heat sources.
Instructions Switching your radio on for the first time 1. Connect the mains adaptor to the DC power socket of the radio and to the power supply from the wall socket. 2. Extend the aerial as far as it can go. 3. ...
Page 7
7. Once the scan has finished, the radio will select the first alphanumerically found station. If you cannot hear any sound, check the volume is switched on. To explore the stations that have been found, you need to turn the “Tune/ Select”...
Page 8
2. Recalling a stored station. Once you have saved a station to one of the presets, you can recall it by pressing and releasing the corresponding preset key, e.g. if you saved Radio 1 to Preset 1, then just press the number 1 preset key.
Page 9
When you press the “Info” button, the display will cycle through the following display modes...
Page 10
1. Signal strength. The slide bar indicates how strong the received signals are, the stronger the signal, the longer the bar will be from left to right. SHOWS THE SIGNAL STRENGTH If the signal level drops below the fifth box (minimum signal level) then you may experience problems with the quality of the audio.
Page 11
5. Set clock. Under DAB mode, the clock will synchronize automatically and you do not have to adjust the clock manually. Turning the volume button to the ’off’ position will turn the radio off and cause the clock to reset. Please set the clock again when you turn on the radio. The stored preset stations will not be affected.
Page 12
13. System Reset. Press and hold the ”Info” button for 3 seconds. The display will show “RESET”. There may be times when you need to reset your receiver back to its original factory settings i.e. when you move the radio to another part of the country. So that you can pick up the local &...
Alarm Mode 1. Check Alarm Status. Under the condition of listening to the radio, press the “alarm” button, the LCD will display the alarm mode. Turn the “Tune/Select” button to set ALARM 1 or ALARM 2 Press down the “Tune/Select” button, and turn the dial to select “ON” or “OFF”.
3. Press down ”Tune/Select” button to Set Alarm’s minute, turn ”Tune/Select” button to change minute 4. Press down “Tune/Select” button to Set Alarm’s repeat mode, turn “Tune/Select” button to change repeat mode. ”DAILY ” or ”ONCE” . 5. Press down “Tune/Select” button to confirm the Alarm setting. The display will return to the Radio Frequency screen.
Page 15
Standby If you press “Standby”, the LCD display will show “Goodbye” and the clock will appear. In standby mode, the device is dormant; pressing “Standby” again reactivates the radio. You can also set the alarm in Standby mode by pressing the “Alarm” key. System Reset Refer to page 11.