MAXTEK 53726 User Manual page 15

Standby
If you press "Standby", the LCD display will show "Goodbye" and the clock
will appear. In standby mode, the device is dormant; pressing "Standby"
again reactivates the radio. You can also set the alarm in Standby mode by
pressing the "Alarm" key.
System Reset
Refer to page 11.
Signal Not Available
When there is no signal received after the Autoscan has been done, the
display will show "OFF AIR". It may be due to a weak signal. Please check if
the Aerial has been pulled out and try again.
Should you experience any technical difficulties, in the first
instance please call our customer support team on the
following number: -
U.K 01270 508538
I.E 1800 995 036
14
14