Hard Floor Cleaning; Cleaning After Use - Bissell ReadyClean 47B2 Series User Manual

O
perations
Empty the collection tank continued
4. Rinse collection tank thoroughly and replace
on unit.
5. Refill solution tank and continue cleaning.

Hard floor cleaning

(select models only)
1. Remove the collection tank (refer to steps
2a and 2b on page 6).
2. attach the hard floor tool by hooking it
into the front of the removable nozzle and
rotate until it snaps firmly in place.
3. Replace the collection tank. be sure to
attach the two latches.
4. fill the solution tank with hot (not boiling)
tap water to the WateR fill line. fill the rest
with bissell 2X hard floor solutions™ to
foRmula fill line.
5. follow steps 1-8 under "carpet cleaning"
on page 6 to continue cleaning.

Cleaning after use

1. unplug the unit.
2. Remove and rinse collection tank thoroughly.
3. Remove tank vent & foam filter (located on
top of the collection tank) and rinse.
4. clean nozzle window by lifting latch and
removing nozzle from machine. Rinse
under running water.
5. 40n7 and 40h5 series models, pop out
crossaction brush by pushing the tabs
away from each other and pushing down.
once the brush pops out, rinse and replace
by snapping the tabs back into place.
6. When finished replace nozzle and secure
with latch.
NOTE: For best results, it is
recommended that the nozzle
is cleaned after each use.
7. Remove lint and hair from red gasket in
base of unit. (do not remove gasket)
8. Replace the collection tank on the base of
the machine and secure with latches.
w w w . b i s s e l l . c o m
WARNING:
to reduce the risk of fire and
electric shock- when cleaning
a hard floor, the bissell hard
floor tool (203-5683) must
be used and it must only be
used with bissell 2X hard
floor solutions cleaning fluid
intended for use with this
appliance.
2.
3.
5.
6.
8 0 0 . 2 3 7 . 7 6 9 1
Meijer.com
4.
4.
7.
7