Carpet Cleaning - Bissell ReadyClean 47B2 Series User Manual

O
perations
Fill the tank continued
3. fill with hot (not boiling) tap water to the
WateR line. fill the rest of the tank with
bissell 2X formula to the foRmula
line. Replace and tighten the black cap.
Caution: Do not microwave or boil
water before filling.
4. Place solution tank on lower body.

Carpet cleaning

1. Plug into proper outlet.
2. adjust the retractable handle by turning
counterclockwise and lifting the handle
up. turn clockwise to secure.
3. With foot press the red power button,
located on the back of the machine.
NOTE: Handle must be in the full
upright position before cleaning.
4. With foot, press the grey recline lever.
located next to power button.
5. cleaning strokes. While pressing the
trigger, make one slow forward wet pass
and another one back.
Caution: Do not overwet.
6. Release the trigger and make one slow
forward and backward pass over the
same area.
7. Repeat steps 5 and 6 until solution being
pulled up appears clean.
8. empty the collection tank when dirty
water reaches the full line, or when the
solution tank is empty.
Empty the collection tank
1. With foot press the red power button, to
turn off and unplug power cord from outlet.
2. Remove the collection tank from base of unit.
2a. Release collection tank latches (on
each side) by pulling up from the bottom
of latch and then out.
2b. carefully remove tank by lifting up
on the tank handle.
3. carry collection tank to a toilet or
sink. to empty, pour out contents using
opening at back of tank.
6
w w w . b i s s e l l . c o m
3.
2.
2a.
3.
Meijer.com
4.
3.
Power
4.
Recline
2b.
8 0 0 . 2 3 7 . 7 6 9 1