Selecting The Remote Controller Signal Code - Fujitsu AU*F12LA Operating Manual

CLEANING AND CARE
Filter Reset (ECONOMY Indicator Lamp fl ashing/ A special setting)
● Can be used if set correctly during installation.
Please consult authorized serviceman when using this function.
• It lights on when it is time to clean the air fi lters.
After turning the power on, press the
MANUAL AUTO button for 2 seconds or
less on the indoor unit.

SELECTING THE REMOTE CONTROLLER SIGNAL CODE

When two or more air conditioners are installed in a room and the remote controller is operating an air conditioner other
than the one you wish to set, change the signal code of the remote controller to operate only the air conditioner you wish to
set (four selections possible).
When two or more air conditioners are installed in a room, please contact your retailer to set the individual air conditioner
signal codes.
Selecting the Remote controller Signal Code
Use the following steps to select the signal code of the remote controller. (Note
that the air conditioner cannot receive a signal code if the air conditioner has not
been set for the signal code.)
1
Press the START/STOP button until only the clock is
displayed on the remote controller display.
2
Press the MODE button for at least five seconds to
display the current signal code (initially set to ).
3
Press the
between
the air conditioner signal code.
4
Press the MODE button again to return to the clock
display. The signal code will be changed.
If no buttons are pressed within 30 seconds after the signal code is displayed, the system returns to the original clock
display. In this case, start again from step 1.
The air conditioner signal code is set to A prior to shipment. Contact your retailer to change the signal code.
The remote controller resets to signal code A when the batteries in the remote controller are replaced. If you use a
signal code other than signal code A, reset the signal code after replacing the batteries.
If you do not know the air conditioner signal code setting, try each of the signal codes (
the code which operates the air conditioner.
/ buttons to change the signal code
. Match the code on the display to
: Flashing
: OFF
) until you fi nd
En-12