CTC Union FRM220-1000DS User Manual

CTC Union Technologies Co.,Ltd.
Far Eastern Vienna Technology Center
(Neihu Technology Park)
8F, No. 60 Zhouzi St., Neihu, Taipei 114,
Taiwan
T +886-2-26591021
F +886-2-26590237
E sales@ctcu.com
techsupport@ctcu.com
marketing@ctcu.com
H www.ctcu.com
2013 CTC Union Technologies Co., LTD.
All trademarks are the property of their respective owners.
Technical information in this document is subject to
change without notice.
User Guide
1.25G MultiRate 2R Transponder
FRM220-1000DS
Table of Contents
Introduction & Features
Specifications
Management Features
Panel/Installation
LED Indicators
Application - CWDM
Console Management
About SFP Units
Version 1.0 Feb. 2013
w w w . C T C U . c o m
------- 1
------- 2
------- 2
------- 3
------- 4
Application ------- 4
------- 5
------- 6-8
Upgrading ------- 8
------- 9
Introduction
FRM220-1000DS is a multi-rate, up to 1.25G 2R optical repeater device.
The "2R" consists of Re-amplification and Re-shaping. The transponder
card converts a data signal to the correct wavelength for transmission on a
specific channel by supporting SFP optics on both line side and client side
interfaces. When FRM220-1000DS card is placed in FRM220 rack with
SNMP management, the management can view the converter card's status,
type, version, fiber link status and alarms. The card can be configured to
enable or disable the port and reset the port.
Features
Supports multiple protocols and data rates from 28Mbps to 1.25Gbps.
Repeater functions for re-amplification and re-shaping.
Low cost transponder application.
Supports rack management or stand-alone (via console).
Supports Auto-Laser Shutdown (ALS) and Link Fault Pass through (LFP).
Digital Diagnostic Monitor of supported SFP modules.
The SFP sockets support a wide range of standard SFP modules to
address any network situation.
Single-mode
Multi-mode
Multi-rate
Single fiber bi-directional
Coarse and Dense Wave Division Multiplexing (CWDM and DWDM)
Copper media
WARNING: Fiber optic equipment may emit laser or infrared light that can
injure your eyes. Never look into an optical fiber or connector port. Always
assume that fiber optic cables are connected to a laser light source.
w w w . C T C U . c o m
- 1 -