CTC Union FRM220-10G Quick Start Manual

CTC Union Technologies Co.,Ltd.
Far Eastern Vienna Technology Center
(Neihu Technology Park)
8F, No. 60 Zhouzi St., Neihu, Taipei 114,
Taiwan
T +886-2-26591021
F +886-2-26590237
E sales@ctcu.com
info@ctcu.com
marketing@ctcu.com
H www.ctcu.com
2010 CTC Union Technologies Co., LTD.
All trademarks are the property of their respective owners.
Technical information in this document is subject to
change without notice.
User Guide
10G 3R Transponder
FRM220-10G
Table of Contents
Specifications
Management Features
Panel/Installation
LED Indicators
Loop Back Diagnostics
Application – Extender/Protection
Application - CWDM
Console Management
Digital Diagnostics
About SFP Units
Version 1.0 May 2010
w w w . C T C U . c o m
Introduction ------- 1
------- 2
------- 2
------- 3
------- 4
DIP Setting ------- 5
------- 6
------- 7
------- 8
------- 9-10
------- 11
Upgrading ------- 12
------- 13
Introduction
The FRM220-10G is a 3R optical regeneration device with clock data
recovery (CDR). The "3R" consists of Re-amplification, Re-shaping and Re-
timing. The transponder card converts a data signal to the correct
wavelength for transmission on a specific channel by supporting XFP,
and/or SFP+ optics on both line side and client side interfaces. When the
FRM220-10G card is placed in the FRM220 rack with SNMP management,
the management can view the converter card's status, type, version, fiber
link status and alarms. The card can be configured to enable or disable the
port, reset the port, provide client or line side diagnostic loopback, and set
the desired data rate.
This card is specifically designed for four popular protocols that run at
near ten gigabit speed. They include 10G Ethernet, 10G Fiber Channel,
OC-192(STM-64) and OTU2.
The XFP and/or SFP+ sockets support a wide range of optical modules to
address any 10 Gigabit network situation.
Single-mode
Multi-mode
Single fiber bi-directional
Coarse and Dense Wave Division Multiplexing (CWDM and DWDM)
Copper media
WARNING: Fiber optic equipment may emit laser or infrared light that can
injure your eyes. Never look into an optical fiber or connector port. Always
assume that fiber optic cables are connected to a laser light source.
w w w . C T C U . c o m
- 1 -