Advertisement
Non-Removable Switch Housing
with Center Hole
Steps 1–2
Attachment
Plug
Switch
Housing
Cover
Step 3
5
Installing the Light Kit on Fans With Non-Removable
Switch Housing
1. Uninstall the two screws from the switch housing cover.
2. Remove the plug or screw from the center of the switch housing
cover.
3. Thread the switch housing cover onto the upper light housing. Align the screw
holes in the upper light housing with the screw holes in the switch housing cover.
Install the nut and washer onto the threaded rod from the light kit to secure the
switch housing cover.
WARNING: Improper installation could cause the light fixture to fall, or result
in electrical shock or personal injury.
4. Remove the wire connectors from the two wires in the switch housing labeled
"Connect Light Here" or "For Light Use." One wire is white and the other wire is
black/white striped.
5. Feed the two wires from the switch housing through the threaded rod in the
upper light housing.
Switch
Housing
6. Align the threaded screw holes in the switch housing cover with the threaded
Cover
holes in the switch housing. Attach the switch housing cover and upper light
housing assembly to the switch housing using the included attachment screws.
7. To connect the wires, hold the bare metal leads together and place a wire
connector over them, then twist the wire connector clockwise until tight.
Screw
Connect the black/white striped wire from the switch housing to the black
wire from the light kit. Connect the white wire from the switch housing to the
Nut
white wire from the light kit. Secure all wire
connections using wire connectors.
Washer
Screw
CAUTION: Be sure no bare metal wires
Hole
or wire strands are visible after making the
connections.
8. Finish attaching the light kit by partially
installing two screws in the upper light
Upper Light
housing. Align the keyhole slots in the
Housing
light kit with the preinstalled screws. Turn
the light kit clockwise until the housing
assembly screws are firmly situated in the
narrow end of the keyhole slots. Install a
third screw into the upper light housing.
Tighten all three screws firmly.
9. Go to the instructions for Installing the Bulbs, Chains, and Globe.
I
Wires
and Wire
connectors
Step 7
43536-01 r111407
O
Advertisement
