Go Spas GO 630 Owner's Manual page 26

Programming Instructions Export
Figure 20 – Topside Callouts for VL600S Controls
Initial Start Up
When your hot tub is first actuated, it will go into Priming mode, indicated by "Pr."
The priming mode will last for less than five minutes. Press "WARM" or "COOL"
to skip Priming Mode and then the hot tub will begin to heat and maintain the
temperature in "Standard Mode."
Warm/Cool Buttons (Set Temperatures between 80°F - 104°F / 26°C - 40°C)
The startup temperature is set at 100°F/37°C. The last measured temperature is
constantly displayed on the LCD and is current only when the pump has been
running for at least two minutes. To display the set temperature, press the
"WARM" or "COOL" button once. To change the set temperature, press the
"WARM" or "COOL" button a second time before the LCD stops flashing. Each
press of the "WARM" or "COOL" button will continue to raise/lower the set
temperature. After three seconds, the LCD will stop flashing and display the
current hot tub temperature.
Jets Button
Press the "JETS" button once to activate the low speed of Pump 1. Press it a
second time to activate the high speed of Pump 1. Press it a third time to turn off
Pump 1. If left running, the high speed of Pump 1 automatically will turn off after
15 minutes and the low speed of Pump 1 automatically will turn off after 4 hours.
The low speed of Pump 1 runs when the "AUX" Blower (if equipped) is on. It may
also active for at least two minutes every half hour to detect the hot tub
temperature and then to heat to the set temperature if needed (depending on
Page 24
For HELP, call 727.573.9611