Electrical Specification And Wiring Diagrams - Go Spas GO 630 Owner's Manual

Electrical Specifications
Important – Qualified and licensed electricians must perform all electrical
hookups. The following specifications must be followed in order to ensure proper
performance and safety.
WARNING: Starting an incorrectly wired hot tub could cause severe damage
to the mechanical equipment or even bodily harm. Have your
licensed electrician verify GFCI (or RCD) wiring with the
diagrams on pages 10-17 prior to starting the hot tub or call the
technical support line at 727.573.9611.
Caution: Failure to abide by specifications listed may result in damage to the
equipment and will void the warranty.
All hot tubs must be wired with the appropriately sized wiring. Failure to do so will
cause equipment damage and will not be covered under your warranty.
All hot tubs must be over current protected with a built-in GFCI (or RCD for
export models) in the service panel.
Volts
Model (V)
1202, 1203, 1204
240
(GO 630) (GO 631) (GO 632)
‡
1202C, 1203C, 1204C
120
(GO 620) (GO 621) (GO 622)
Table 2 – Domestic Wire Size Chart
Volts
Model (V)
1202EX,1203EX,1204EX
GO 630EX, GO 631EX,
220-
GO 632EX
1202BEX,1203BEX,1204BEX, 240
GO630BEX, GO631BEX,
GO632BEX
Table 3 – Export (Overseas) Wire Size Chart
WARNING: Disconnect electrical power before servicing. Before obtaining
access to terminals, all supply circuits must be disconnected.
*
Wire size may need to be reduced at GFCI to fit into the breaker
†
Solid copper
‡
Available in 120V (also referred to as 110 volts)
§
Solid copper
Freq. Rating GFCI Wire size from GFCI
(Hz) (A) (A) to Main Panel
6-3 plus ground (up to 130')
60 40 50 4-3 plus ground (up to 230')
2-3 plus ground (up to 360')
12-2 plus ground (up to 130')
60 16 20 10-2 plus ground (up to 230')
8-2 plus ground (up to 360')
Ratin
g RCD Wire size from RCD
(A) (A) to Main Panel
1x32 IEE Wire
2x16 Regulation
Page 9
For HELP, call 727.573.9611
Equipment
*†
Pack
VS500Z
VS500Z
Equipment
§
Pack
2
3x4 mm
GS510SZ
2
5x1.5 mm