Topside Control - Go Spas GO 630 Owner's Manual

T o p s i d e C o n t r o l
Programming Instructions Domestic
Figure 19 –Topside Control Panel
Lamps

When the Jets LED is on steady, the system is in a filtration cycle.

When the Temp LED is flashing, the system is checking the water
temperature.

When the Temp LED is on steady, the system is heating the water.
Water Temperature
Press Cool or Warm to select the desired temperature. The desired temperature
setting displays for five seconds to confirm your new selection and then displays
the actual water temperature. The default temperature is 100ºF.
Filtration Cycle
Start Time – Reset the controller by power cycling (power off). After the five
minute priming, the filtration cycle starts 12 hours later. To skip the priming
period, press Cool/Warm.
Duration – Press Cool/Warm, then Jets. Press Cool/Warm to adjust to 2, 4, 6, or
8 hours, or to continuous filtration (as indicated by FC on the display). Press Jets
to exit. The default duration is 2 hours.
Frequency – The filtration frequency is fixed at twice a day.
Standard, Economy, and Sleep Modes
Press Cool/Warm and then Light to set the operating mode. Press Light to
advance between modes.
Standard (Std) mode maintains the desired water temperature all the time.
Economy (Ecn) mode turns on the heater only during filtration cycles and
tries to maintain the desired water temperature.
Sleep (SLP) mode turns on the heater only during filtration cycles and drops
the water temperature 20°F (11°C) below the desired water temperature.
(MVP 260 Domestic)
Page 23
For HELP, call 727.573.9611