Table of Contents
Advertisement
Troubleshooting Guide
Caller ID Solutions
No Display
• The battery must be fully charged. Try replacing the battery.
• Make sure that the unit is connected to a non-switched electrical
outlet. Disconnect the unit from the wall and plug it in again.
• You must be subscribed to Caller ID service from your local telephone
company in order to receive Caller ID records.
Caller ID Error Message
• This message indicates either the presence of noise on the line, or that
an invalid message has been sent from the telephone company.
Cordless Phone Solutions
No dial tone
• Check installation:
Make sure the base power cord is connected to a working electrical
outlet.
Make sure the telephone line cord is connected to the base unit and the
wall phone jack.
• Connect another phone to the same modular jack; if the second phone
doesn't work, the problem might be with your wiring or local service.
• The handset may be out of range of the base. Move closer to the base.
• Make sure the battery is properly charged (for 16 hours).
• Ensure the battery pack is installed correctly.
• The handset should beep when you press the talk button, and the
charge indicator on the base should be lit when the handset rests in the
cradle. If not, the battery may need to be charged.
• Place the handset in the base for at least 0 seconds to reset unit.
56
Advertisement
Table of Contents
