Advertisement

Quick Links

pumps

Pressure Washer

Operating Instructions

Model
Serial No.
Engine No.
pumps
Year of Manufacture
Unit 8, Hudson Road
CE
Saxby Road Ind. Est.
Melton Mowbray
Leicestershire LE13 1BS
Telephone: +44 (0)1664 567226
Fax: +44 (0)1664 410127
793-1200
E-mail: info@dualpumps.co.uk
www.dualpumps.co.uk

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Pressure Washer and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Dual Pumps Pressure Washer

  • Page 1: Pressure Washer

    Pressure Washer Operating Instructions Model Serial No. Engine No. pumps Year of Manufacture Unit 8, Hudson Road Saxby Road Ind. Est. Melton Mowbray Leicestershire LE13 1BS Telephone: +44 (0)1664 567226 Fax: +44 (0)1664 410127 793-1200 E-mail: info@dualpumps.co.uk www.dualpumps.co.uk...
  • Page 2: Appendix 1. Lance Variations

    Appendix 1. Lance variations HIGH PRESSURE JET LOW PRESSURE JET...
  • Page 3 Dual Pumps Ltd products on behalf of Dual Pumps Ltd, or to assume for Dual Pumps Ltd the obligations contained in this warranty. Dual Pumps Ltd reserves the right to make changes in...
  • Page 4: Ec Declaration Of Conformity

    Fault Finding ..................section 9 Warranty ....................section 10 The liability of Dual Pumps Ltd under the foregoing warranty is limited to the repair Lance Variations ................appendix 1 or replacement at Dual Pumps Ltd option without charge for labour, mileage costs...
  • Page 5: Fault Finding

    Variants and Options (fig 1) Fault Finding SPL = Sound Power Level on equipment representative for this type. Symptom Possible Cause Remedy GSPL = Guaranteed Sound Power Level for this equipment. Pump running normally Lance in low pressure mode Check and adjust GSPL but pressure low.
  • Page 6: Maintenance

    3. Safety 7. Maintenance Power washers should only be used by fully trained, competent persons. They Activity Each/ 3 months 12 months or should not be used by untrained or inexperienced users. First Use or 50 Hours 100 hours Care should be taken when handling the pressure washers as they have uneven Inspect / top up oil levels Engine centres of gravity and may topple over when lifted.
  • Page 7: Operation

    6. Operation Control of Vibration at Work Regulations 2005 Start engine (Note: Depress the lance trigger to release water pressure This machine in its standard form dose not exceed the 2.5 m/s² vibration action before starting the engine). value and should not require any daily limitations to it use. Periodic equipment Refer to accompanying booklet relating to the type of engine fitted.
  • Page 8: Installation

    5. Installation 4. Description of Main Features (fig 2) From the pump and gearbox (if fitted) remove the ‘Red’ travel plugs, replacing them with the yellow-topped dipsticks. Check all oil levels, top up if necessary. ALTERNATIVE Fill engine with oil and fuel, see engine manufacturers handbook VALVE ASSEMBLY RETURN TO TANK BY-PASS for details of oil and fuel types.

Table of Contents