Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Dual Pumps LC Series
Summary of Contents for Dual Pumps LC Series
- Page 1 793-1201 SERIES SERIES LCT9160PLR Original Manufacturer Instructions...
-
Page 3: Table Of Contents
Introduction This manual and any other literature supplied must be read fully prior to the initial operation of your machine and be stored for later use or for subsequent owners. Pay particular attention to any instructions relating to operation and safety and maintenance of the unit. - Page 4 1. Component Identification - Main Machine 1-11 1-10 1-12 1-14 1-13 - Pump Close Up...
-
Page 5: Component Identification
1. Component Identification - Accessories Item No. Main Machine Photos Trolley Frame Trolley Wheels Engine High Pressure Pump Engine Oil Dipstick & Filler Engine Ignition On/Off Switch Engine Recoil Starter Pull Cord Engine Fuel Tank Fuel Filler Cap 1-10 Engine Choke Lever 1-11 Engine Throttle Control 1-12... -
Page 6: Technical Specification
2. Technical Specification Model No. LCT9160PLR Engine Loncin G200-F Fuel Petrol Power 6.5 HP (4.85 kW) - SAE J1349 Nominal Rpm 3400-3600 Starting Method Recoil start Fuel Tank 3.6 Litres Max Feed Temperature 40°C Minimum Feed Flow Rate 11 Lpm Maximum Feed Pressure 1 MPa - 10 Bar - 145 psi Maximum Suction Depth... -
Page 7: Intended And Proper Use - Domestic
3. Intended and Proper Use - Domestic for Private Households Only This machine is intended for Domestic use and is not suitable for Commercial and Industrial purposes. The machine must not be used by children or vulnerable people. Users should be familiar with the contents of this user manual and wearing protective clothing to the required health &... -
Page 8: Safety Devices
This machine has been designed for use only with cleaning agents approved by the manufacturer. The use of other cleaning agents or chemicals may adversely affect the safety of the machine. High pressure jets can be dangerous if subject to misuse. The jet must not be directed at persons, animals, live electrical equipment or the machine itself. -
Page 9: Standard Accessories
6. Standard Accessories The LCT9160PLR pressure washer is supplied with the following accessories. Make sure all the items listed are included when unboxing for the first time. • Two part high pressure lance assembly • 8m high pressure hose assembly In case of transport damage inform vendor immediately. - Page 10 7. Pre-Operation Checks and Set Up CHECKS CHEMICAL - If using chemical, fill the integrated chemical tank with an appropriate cleaning product. Always check compatibility before using a chemical. SET UP Mains Water Hose Mains Water Hose THIS PRESSURE WASHER MUST BE MAINS FED.
-
Page 11: Start Up And Operation
The fan jet Pull the trigger on the gun and lance can be adjusted by twisting the assembly, the LC Series pressure nozzle head. washer is now ready to use. -
Page 12: Stopping Procedure
9. Stopping Procedure • DRAIN PUMP - Turn off and disconnect the mains water supply and drain the water from the pump by allowing the machine to run for a few seconds with the trigger gun open until no water is coming from the high pressure jet. •... -
Page 13: Maintenance Information
12. Maintenance Information Maintenance and servicing of the machine must only be undertaken by suitably trained and qualified technicians. Unloader Valves must only be adjusted and serviced by suitably trained and qualified technicians. Ensure all steps from the Decommissioning & Storage section have been carried out before starting any work on the machine. -
Page 14: Troubleshooting
14. Troubleshooting Symptom Possible Cause Remedy Pump running normally Pressure Regulator valve Check and adjust but pressure low. Pump sucking air. Check water supply and possible air ingress. Lance in low pressure mode Check and adjust see page 9 Nozzle badly worn Check and/or replace Worn piston packing Seek professional advice... -
Page 15: Warranty Information
2011/65/EU - RoHS Directive Applied Harmonised Standards EN60335-1-2012-A13-2017 EN60335-2-79-2012 EN1829-2-2008 EN4871-2009 Manufacturer Dual Pumps Ltd, Saxby Road Industrial Estate, Melton Mowbray, LE13 1BS. United Kingdom Person authorised to compile the technical file & declaration Tom Herridge, Director Signed – Date – 02/3/2020... - Page 16 Unit 8, Hudson Road Saxby Road Ind. Est. Melton Mowbray Leicestershire LE13 1BS Telephone: +44 (0)1664 567226 Fax: +44 (0)1664 410127 E-mail: info@dualpumps.co.uk www.dualpumps.co.uk...
Need help?
Do you have a question about the LC Series and is the answer not in the manual?
Questions and answers