Char-Broil 463261709 Product Manual page 19

12
Insert front brace under control panel and between cart side panels. Make sure door hinge pins are on the top side and
facing the front. Secure using two 1/4-20x1½" screws, 7mm lock washers, and 7mm flat washers on each side.
NOTE: MAKE SURE THAT THE FRONT BRACE IS MOUNTED IN THE MOST DOWNWARD POSITION WHEN
ASSEMBLED TO CART.
13
Inside of cart, insert rear shield tab into left slot on upper of lower back panel.
beneath grease tray opening in upper back panel, shown A.
left rails under front brace with three #8x3/8" self-tapping screws, shown B.
Tank heat shield
Tank heat shield
Front brace
Note: some parts omitted
for clarity of illustration
Cart lower back panel
Left rail
Right rail
Attach front shield tabs under front brace and attach right and
Tank heat shield
*This side UP
A
Door
Hinge Pin
7mm flat 7mm lock
washer
washer
Insert left and right grease tray rails into slots
Front Brace
#8x3/8"
self-tapping screw
Left rail
1/4-20x1½"
screw
B
Right rail
Grease tray opening
19