Declaration Of Conformity; Mode Changes; Mechanical Conversion - Spektrum DX8 Instruction Manual

The following information is for item numbers: SPM8800EU
AT BG CZ
DK ES FI
IE IT LT
MT NL PL
SE SI SK
The following information is for item numbers: SPM88001FR
AT BG CZ
DK ES FI
HU IE IT
LV MT NL
RO SE SI

Declaration of Conformity

(in accordance with ISO/IEC 17050-1)
No. HH2010080203
Product(s): Spektrum DX8 Transmitter
Item Number(s): SPM8800EU, SPM88001FR
Equipment class: 2
The object of declaration described above is in conformity with the
requirements of the specifications listed below, following the provisions of
the European R&TTE directive 1999/5/EC:
EN 60950 Safety
EN 300-328 Technical requirements for Radio equipment
EN 301 489 General EMC requirements for Radio equipment
Signed for and on behalf of:
Horizon Hobby, Inc.
Champaign, IL USA
Steven A. Hall
Aug 02, 2010
Vice President
International Operations and Risk Management
Horizon Hobby, Inc.
This product must not be disposed of with other waste. Instead,
it is the user's responsibility to dispose of their waste equipment
by handing it over to a designated collection point for the recycling of waste
electrical and electronic equipment. The separate collection and recycling of
your waste equipment at the time of disposal will help to conserve natural
resources and ensure that it is recycled in a manner that protects human
health and the environment. For more information about where you can drop
off your waste equipment for recycling, please contact your local city office,
your household waste disposal service or where you purchased the product.
CY DE
GR HU
LU LV
PT RO
UK
CY DE
FR GR
LT LU
PL PT
SK UK
The DX8 can be easily converted to mode 1, 2, 3, or 4. This conversion requires
a mechanical and a programming change. (Stick and switch positions for mode
1 and 2 are illustrated on pages 8 and 9.) Following are detailed instructions on
making mode changes
Mechanical conversion is required to switch between modes 1 and 2 or between
modes 3 and 4. The centering spring for elevator and the friction straps for
throttle must be engaged on the appropriate gimbal and throttle limiting wedges
must be swapped.
Step 1. Carefully pull back the rear grips and side rubber panels and unscrew
the six Phillips head screws shown.
Step 2. Remove the back case noting that a wire harness connects the back
to the main case. Carefully set the main case to the left side of the
transmitter being careful not to damage the wire harness.
(Cages are pictured in white for clarification. The cages
in your transmitter are black.)
Step 3. Locate the silver throttle friction straps on both gimbals. Two straps are
located on each gimbal. One strap engages a serrated section on the
gimbal giving a ratcheted throttle feel while the other strap engages a
smooth section on the gimbal giving a smooth friction feel.
EN
39