Page 1
PRESSURE WASHERS STOCK No.34390. PART No.PW2000. STOCK No.38419. PART No.PW2110. STOCK No.54435. PART No.PW2121. STOCK No.52588. PART No.PW2130. • INSTRUCTIONS • IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY TO ENSURE THE SAFE AND EFFECTIVE USE OF THIS TOOL. 06/99...
This guarantee applies in lieu of any other guarantee expressed or implied and variations of its terms are not authorized. Your Draper guarantee is not effective unless you can produce upon request a dated receipt or invoice to verify your proof of purchase within the 12 month period.
PW2110 PW2121 Now referring to Fig.1. carefully check that all the parts are present. Please contact the Draper Power Helpline (01703) 494344 if you have any enquiries ie. problems with assembly, apparent missing/damaged parts, help with accessories available or technical advice.
(i.e. red). Fuse covers are available from your Draper Tools stockist. If the fitted plug is not suitable, it should be cut off and destroyed. *The end of the cable should now be suitably prepared and the correct type of plug fitted.
Please read the following instructions carefully, failure to do so could lead to serious personal injury. IMPORTANT Draper Tools Limited recommends that this machine should not be modified or used for any application other than that for which it was designed. If you are unsure of its relative applications do not hesitate to contact us in writing and we will advise you.
ADDITIONAL SAFETY RULES FOR PRESSURE WASHERS 1. The pressure washer must be continuously run with water. Dry running may cause serious damage to the seals. 2. Do not store the pressure washer in cold places and protect the machine from freezing conditions. 3.
KNOW YOUR PRESSURE WASHER PW2000 PW2110 PW2121 PW2130 ON/OFF switch Transport handle/lance support High pressure outlet BS Approved non-rewireable moulded plug & cable Water inlet connector Hose pipe connector Lance NOTE: The upright High presure hose connector position is for transportation and Pressure regulator storage only.
ASSEMBLY Fig.2. 1. Secure the lance nozzle assembly Fig.2. into the handle assembly by locating the male connector on the lance into the female connector in the handle and turning as shown in Fig.3. Fig.3. 2. Now repeat the operation and secure the high Fig.4.
Page 10
ASSEMBLY Cont’d 4. Ensuring that the rubber sealing washer is Fig.7. correctly seated inside the hose pipe connector, connect the hose pipe to the water inlet connector as shown in Fig.7. NOTE MAXIMUM WATER TEMPERATURE 50ºC (120ºF). 5. Next connect the high pressure output hose Fig.8.
HIGH PRESSURE CLEANING The output water pressure is preset and cannot be adjusted, the maximum pressure produced is 100 bar (for PW2000), 110 bar (for PW2110). Draper Tools recommends that before carrying out any cleaning operations always test a small inconspicuous part of the area to be cleaned to check that it is suitable.
OPERATION Cont’d PW2000, PW2110 AND PW2121 Cont’d Fig.16. 3. Fit the detergent spraying attachment to the handle assembly in the same way as when fitting the lance assembly See Fig.16. 4. Fill the detergent bottle with detergent to the Fig.17. required level See Fig.17.
Page 13
The output pressure is indicated on the gauge Fig.22. Fig.22. Draper Tools recommends that before carrying out any cleaning operations always test a small inconspicuous part of the area to be cleaned to check that it is suitable.
Page 14
OPERATION Cont’d PW2130 Cont’d Fig.26. 2. Aim the lance spray nozzle in the required direction See Fig.26. 3. Pull the trigger on the handle. The water will now spray from the lance. Adjust to the required spray pattern as shown in Fig. 23 and 24. To stop spraying release the trigger.
MAINTENANCE WARNING - FOR YOUR OWN SAFETY, TURN Fig.31. SWITCH OFF AND REMOVE THE PLUG FROM THE POWER SUPPLY OUTLET BEFORE MAINTAINING YOUR PRESSURE WASHER. Lubrication - Your pressure washer is supplied as a sealed unit and does not require further lubrication.
TROUBLESHOOTING WARNING: FOR YOUR OWN SAFETY TURN SWITCH OFF AND REMOVE PLUG FROM POWER SUPPLY. Trouble Probable Cause Remedy No power Pump is stuck Turn the motor manually (see page 15). Thermal overload has tripped Switch OFF and let the machine cool Faulty power cable This should be replaced immediately by a qualified person...
OPTIONAL ACCESSORIES The following accessories are available from your local Draper Power Tool Stockist. Accessories for Models PW2000, PW2110, PW2121 and PW2130 Pressure Washers Unit of Sale: 1 (exceptions shown below table). Stock Part Description Turbo Lance for PW2110 34448...
Page 18
PRESSURE WASHER ACCESSORIES SUITABLE FOR USE WITH DRAPER MODELS AND OTHER MANUFACTURER’S SIMILAR MACHINES. PW2220 PW2210 PW3000 PW2121 PW2111 09/2001...
Page 19
TROLLEY/WHEEL KIT I STOCK No. 61225 I PART No. APW30 FOR USE WITH DRAPER PRESSURE WASHER STOCK No.61098 PART No.PW2111 PW2111 The trolley/wheel kit complete with transport handle makes the machine more manoeuvrable than before, whilst still offering stability during use.
Page 20
TURBO LANCE I STOCK No. 57354 I PART No. APW17 FOR USE WITH DRAPER PRESSURE WASHER STOCK No.56456 PART No.PW2220 I STOCK No. 57361 I PART No. APW24 FOR USE WITH DRAPER PRESSURE WASHER STOCK No.56457 PART No.PW3000 I STOCK No. 65822 I PART No.
Page 21
WASHING BRUSH (FIXED HEAD) I STOCK No. 34449 I PART No. APW3 FOR USE WITH DRAPER PRESSURE WASHERS STOCK No.61098 PART No.PW2111 STOCK No.54435 PART No.PW2121 I STOCK No. 57355 I PART No. APW18 FOR USE WITH DRAPER PRESSURE WASHER STOCK No.56456...
Page 22
ROTARY WASHING BRUSH I STOCK No. 34450 I PART No. APW4 FOR USE WITH DRAPER PRESSURE WASHERS STOCK No.61098 PART No.PW2111 STOCK No.54435 PART No.PW2121 I STOCK No. 57356 I PART No. APW19 FOR USE WITH DRAPER PRESSURE WASHER STOCK No.56456 PART No.PW2220...
Page 23
EXTENDED LANCE - 1500mm I STOCK No. 34456 I PART No. APW9 FOR USE WITH DRAPER PRESSURE WASHERS STOCK No.61098 PART No.PW2111 STOCK No.54435 PART No.PW2121 PW2111 PW2121 This extended lance increases the reach of the water jet. Ideal for use on caravans, high sided vehicles and conservatories, etc.
HIGH PRESSURE HOSE I STOCK No. 65820 I PART No. APW32 FOR USE WITH DRAPER PRESSURE WASHER STOCK No.65376 PART No.PW2210 PW2210 FITTING INSTRUCTIONS Refer to manufacturer’s instruction manual. - 6 -...
Page 25
LANCE EXTENSION PIECE - 180mm I STOCK No. 34455 I PART No. APW8 FOR USE WITH DRAPER PRESSURE WASHERS STOCK No.61098 PART No.PW2111 STOCK No.54435 PART No.PW2121 PW2111 PW2121 The reach of the standard lance can be increased by 180mm, with every extension piece added.
Page 26
PIPE/DRAIN CLEANER I STOCK No. 34451 I PART No. APW5 FOR USE WITH DRAPER PRESSURE WASHERS STOCK No.61098 PART No.PW2111 STOCK No.54435 PART No.PW2121 I STOCK No. 57357 I PART No. APW20 FOR USE WITH DRAPER PRESSURE WASHER STOCK No.56456 PART No.PW2220...
Page 27
SANDBLASTING ATTACHMENT I STOCK No. 34452 I PART No. APW6 FOR USE WITH DRAPER PRESSURE WASHERS STOCK No.61098 PART No.PW2111 STOCK No.54435 PART No.PW2121 I STOCK No. 57358 I PART No. APW21 FOR USE WITH DRAPER PRESSURE WASHER STOCK No.56456 PART No.PW2220...
Page 28
DETERGENT SPRAY ATTACHMENT I STOCK No. 34454 I PART No. APW7 FOR USE WITH DRAPER PRESSURE WASHERS STOCK No.61098 PART No.PW2111 STOCK No.54435 PART No.PW2121 PW2121 PW2111 This 0.5 litre detergent spray attachment, provides the facility for in-line application of cleaning agents, such as shampoo, wash and wax, traffic film remover, etc.
Page 29
REPLACEMENT LANCE I STOCK No. 54254 FOR USE WITH DRAPER PRESSURE WASHER STOCK No.61098 PART No.PW2111 I STOCK No. 62128 FOR USE WITH DRAPER PRESSURE WASHER STOCK No.54435 PART No.PW2121 I STOCK No. 65821 I PART No. AWP33 FOR USE WITH DRAPER PRESSURE WASHER STOCK No.65376...
Page 30
HOSE REEL (WITHOUT HOSE) I STOCK No. 56458 I PART No. APW15 FOR USE WITH DRAPER PRESSURE WASHERS STOCK No.56456 PART No.PW2220 STOCK No.56457 PART No.PW3000 PW2220 PW3000 The hose reel provides easy and safe storage on board the machine for the high pressure hose.
Page 31
BODYWORK LANCE I STOCK No. 57353 I PART No. APW16 FOR USE WITH DRAPER PRESSURE WASHER STOCK No.56456 PART No.PW2220 I STOCK No. 57360 I PART No. APW23 FOR USE WITH DRAPER PRESSURE WASHER STOCK No.56457 PART No.PW3000 PW2220 PW3000 This bodywork lance is an efficient method of cleaning cars, caravans, boats and motorcycles, etc.
Page 32
TWIN LANCE I STOCK No. 57359 I PART No. APW22 FOR USE WITH DRAPER PRESSURE WASHER STOCK No.56457 PART No.PW3000 PW3000 This twin lance is an industrial high and low pressure attachment. FITTING INSTRUCTIONS Remove existing lance and fit the extended lance to the handle assembly, refer to manufacturer’s instruction manual.
Page 33
TRIGGER ASSEMBLY I STOCK No. 65819 I PART No. APW31 FOR USE WITH DRAPER PRESSURE WASHER STOCK No.65376 PART No.PW2100 PW2210 FITTING INSTRUCTIONS Remove existing handle assembly and fit the replacement trigger assembly, refer to manufacturer’s instructions. - 15 -...
Page 34
PRESSURE WASHER CONSUMABLES STOCK No. PART No. DESCRIPTION 34649 PWW1 Vehicle Wash and Wax shampoo 1 Litre 34648 PTFR1 High Foam Traffic Film Remover 1 Litre 34706 PWW5 Vehicle Wash and Wax Shampoo 5 Litre 34664 PTFR5 High Foam Traffic Film Remover 5 Litre - 16 -...
Need help?
Do you have a question about the 34390 and is the answer not in the manual?
Questions and answers