Commercial copying, redistribution, hiring or lending is prohibited. No part of this publication may be stored in a retrieval system or transmitted in any other form or means without written permission from Draper Tools Limited. In all cases this copyright notice must remain intact.
This guarantee applies in lieu of any other guarantee expressed or implied and variations of its terms are not authorised. Your Draper guarantee is not effective unless you can produce upon request a dated receipt or invoice to verify your proof of purchase within the guarantee period.
This manual is intended to give an overview of this machines features, functionality and safe operation. 4.2 SPECIFICATION Stock no..........................83818 Part no..........................PPW650 Engine ........................6.5HP 4-stroke Engine displacement ......................196cc Speed (no load) ....................3350-3550 r/min Working pump pressure ..................168bar (2430psi) Max.
HEALTH & SAFETY INFORMATION 5.1 GENERAL SAFETY INSTRUCTIONS FOR POWER TOOL USE When using any type of power tool there are steps that should be taken to make sure that you, as the user, remain safe. Common sense and a respect for the tool will help reduce the risk of injury. Read the instruction manual fully.
Page 7
HEALTH & SAFETY INFORMATION Wear personal protective equipment (PPE). Dust, noise, vibration and swarf can all be dangerous if not suitably protected against. If the work involving the power tool creates dust or fumes; wear a dust mask. Vibration to the hand, caused by operating some tools for longer periods must be protected against.
HEALTH & SAFETY INFORMATION SPECIFIC SAFETY INSTRUCTIONS FOR PRESSURE WASHER USE Warning: This appliance is for outdoor use only. Warning: Always disconnect the electricity and water supplies on completion of ever job. Warning: Never use the appliance if the electrical cable or important parts of the appliance are damaged, e.g.
Page 9
HEALTH & SAFETY INFORMATION Warning: Every machine is tested in its operating conditions, so it is normal for a few drops of water to be left inside it. Warning: Take care not to damage the electric cable. Have a damaged power cord replaced immediately by an authorized service point or an electrical specialist.
Lay the contents out and check them against the parts shown below. If any part is damaged or missing; please contact the Draper Helpline (the telephone number appears on the Title page) and do not attempt to use the machine.
ASSEMBLING THE PRESSURE WASHER WARNING: Unit is heavy. Do not attempt to lift and remove the pressure washer from the box. The pressure washer comes almost fully assembled. HOSE AND CABLE TIDY - FIG.1 & 2 FIG.1 The machine comes with the handle and nozzle panel in the storage/transport position.
ASSEMBLING THE PRESSURE WASHER LANCE TO GUN- FIG.5 FIG.5 SELECTING THE RIGHT NOZZLE - FIGS.6-10 NOTE: To prevent damage to your surface and to select an appropriate nozzle size for your application, always start with the lowest pressure nozzle (white) and continue changing to the higher nozzle size until the best result is achieved.
ASSEMBLING THE PRESSURE WASHER FIG.9 FIG.10 NOZZLES TO LANCE - FIG.11 WARNING: Never place hands in front of nozzle. Never grasp hose or fittings durin operation. Never attempt to attach or remove spray wand or hose fittings while pressure washer system is pressurised. Turn off pressure washer and lock the gun trigger before attempting to change pressure nozzles.
PREPARING THE PRESSURE WASHER WARNING: Improper treatment of the pressure washer can damage internal components and shorten the life of this unit. Failure to follow this warning will void warranty. ADDING ENGINE OIL - FIG.13 FIG.12 FIG.13 LOW OIL SENSOR...
PREPARING THE PRESSURE WASHER ADDING PETROL - FIG.14 FIG.14 WARNING: Petrol and petrol vapour are extremely flammable and explosive. Fire or explosion from misuse of fuel can cause severe burns and even death. Failure to us fuel as recommend in this manual will void the warranty. USING PRESSURE WASHER AT HIGH ALTITUDES...
10. OPERATING THE PRESSURE WASHER 10.1 STARTING WARNING: DO NOT run the pump without the water supply connected and turned on. Damage to the pressure washer resulting from failure to follow this instruction WILL void the warranty. WARNING: Do not leave pressure washer in bypass mode for more than two minutes at a time.
10. OPERATING THE PRESSURE WASHER WARNING: The high pressure stream of water that this equipment produces can cu through skin and it’s underlying tissues, leading to possible amputation. gun traps high water pressure, even when the motor is stopped and water is disconnected, which can cause injury.
10. OPERATING THE PRESSURE WASHER 10.4 EXHAUST CONTROL SYSTEM With the engine running, carbon monoxide, nitrogen oxide and hydrocarbon are produced, and in certain conditions nitrogen oxide and hydrocarbon will react together to make smoke while carbon monoxide is toxic, so exhaust control is very important. The manufacturer decreases exhaust emissions by introducing poor-fuel carburetors and other devices to solve the problem.
10. OPERATING THE PRESSURE WASHER 10.6 USING CHEMICALS AND CLEANING SOLVENTS NOTE: Use only soaps and chemicals designed for use with pressure washers. DO NOT USE CHLORINE BLEACH. Chemicals, soaps and cleaning solvents will not siphon when a high pressure nozzle used.
10. OPERATING THE PRESSURE WASHER WARNING: Leaving chemicals and cleaning solutions inside the pressure pump could damage it. Damages created by leaving soaps, chemicals and cleaning solutions inside the pump can void the warranty. IMPORTANT: DO NOT get closer than 20cms when cleaning. 10.7 SHUTTING DOWN IMPORTANT: Never turn off water supply with engine running.
11. MAINTENANCE 11.4 CLEANING PRESSURE WASHER 11.5 STORAGE WARNING: Petrol and petrol vapour are extremely flammable and explosive. Fire or explosion from misuse of fuel can cause severe burns or death. ENGINE NOTE: DO NOT store petrol from one season to another unless it’s been treated with fuel stabilser.
Page 25
11. MAINTENANCE WARNING: Unintentional sparking can cause fire or electrical shock. Failure to observe this warning can cause severe property damage, severe burns and even death. Disconnect spark plug wire from spark plug and cover tip of spark plug wire with insulating tape and place wire where it cannot come in contact with spark plug or pressure washer frame.
11. MAINTENANCE PRESSURE WASHER WARNING: Certain storage covers can be flammable or can melt in higher temperatures. Do not place storage cover over pressure washer unit until it has completely cooled. 11.6 PREPARING FOR USE AFTER STORAGE...
12. TROUBLESHOOTING 13. DISPOSAL 15.1 DISPOSAL - At the end of the machine’s working life, or when it can no longer be repaired, ensure that it is disposed of according to national regulations. - Contact your local authority for details of collection schemes in your area. In all circumstances: •...
Page 32
- Sales Desk: (023) 8049 4333 - General Enquiries: (023) 8026 6355 - Service/Warranty Repair Agent For aftersales servicing or warranty repairs, please contact the Draper Tools Helpline for details of an agent in your local area. YOUR DRAPER STOCKIST DKDH1115...
Need help?
Do you have a question about the PPW650 and is the answer not in the manual?
Questions and answers