Monitor Status Function Menu; Current Faults Function Menu - Comtech EF Data UT-4505 Installation And Operation Manual

UT4500 Series Up Converter
System Operation
3.3.3.2 C
ONFIGURE
This command allows the local operator to pre-select from 1 to 32 frequencies to pre-set
a programmed frequency channel and attenuation setting.
3.3.3.3 C D
LEAR ATA
This command allows the local operator to clear a pre-set frequency and attenuation
setting from a pre-selected converter.
3.3.3.4 P
ROGRAM
This command allows the local operator to input a pre-set frequency channel and
attenuation settings into a converter.
3.3.4 M
ONITOR
Monitors and displays the status of:
15 and 14 Vdc power supplies.
Converter internal temperature.
IFLO tuning voltage level.
Synthesizer Sum., Coarse and Fine Loop tuning.
3.3.5 C
URRENT
Displays the status of the current fault conditions. The LCD display will indicate "FT"
when a fault condition exists. The display will indicate "OK" when a fault has not
occurred.
3.3.5.1 P F
OWER
Displays the DC voltage power supply faults.
15 Vdc Power Supply.
14 Vdc Power Supply.
VCC voltage.
3.3.5.2 C
ONVERTER
Displays the converter oscillator faults:
IFLO Lock Detect.
Reference Oscillator Lock Detect (only present if external reference is detected.).
C T
ONVERTER O
F P -S
ROM RE ELECT
P -S
RE ELECT
S F
TATUS UNCTION
F F
AULTS UNCTION
AULTS
O F
SCILLATOR
P -S
RE ELECT
M
ENU
M
ENU
AULTS
37
MN/UT4500.IOM
Revision 2