Table of Contents
Advertisement
Managing Switches
Switch Status
Status - Port Status
The Port Status page (switches only) displays the operational status of each
switch port. The settings can be changed in the Configuration - Port
Configuration page.
The Port Status settings are described in the following table.
Table 7-1.
7-4
Port Status Settings
Setting
Description
Port
The port number.
Port Type
The network type of each switch port, for example, 100TX.
Enabled
Whether the port is enabled or disabled.
Link Status
The port's current operational status. Up means the port is working
correctly. Down means the port is disabled.
Current Mode
The operational mode of the port.
• 10/100 Base TX - Can be 10 Mbits half or full duplex or 100 Mbits
half or full duplex.
• 100 Base FX - Can be 100/full duplex or 100/half duplex.
• Gigabit - Can only be 1000 full duplex.
Flow Control
Indicates the current state of flow control for this port.
• 10/100TX, 10 FL, 100 FX:
– On - Flow control is enabled.
– Off - Flow control is disabled (default).
• Gigabit:
– On (TX, RX) - Flow control is enabled on transmit and
– On (RX) - Flow control on receive only.
– Off (default) - Flow control is disabled.
Bcast Limit (not
The Broadcast Limit, expressed as a percentage of broadcast
available on
packets relative to the theoretical limit. Any broadcast or multicast
traffic exceeding this limit will be dropped. A value of zero
the HP J3298 A or HP
indicates that no limit is to be applied. Values range from 0-99.
J3299A)
receive.
Advertisement
Table of Contents
