Table of Contents
Advertisement
Running HP Hub & Switch Management
This chapter describes how to start and stop HP Hub & Switch Management.
It includes the following topics:
Note: Before you begin, you should ensure that the network devices are
properly set up for IP operation. For information on setting up HP
network devices, see
Starting the Manager Application
The entire product set that you have installed is started as one application,
"the manager", on your management station. In other words, HP Hub &
Switch Management starts along with Network Node Manager.
Starting HP OpenView
Do the following steps to start your product.
1.
Starting the Manager Application
Verifying Installation of the Manager Product Set
Stopping and Restarting the Manager Application
Appendix A
Add /opt/OV/bin to your path using one of the commands below. Note
that you only need to do this the first time you start the HP OpenView
manager software.
For These Shells
/bin/ksh or /bin/
sh
/bin/csh
.
Use These Commands
PATH=$PATH:/opt/OV/bin:/usr/sbin
export PATH
setenv PATH "$PATH:/opt/OV/bin:/usr/
sbin"
4
4-1
Advertisement
Table of Contents
