Table of Contents
Advertisement
Color profile: Generic CMYK printer profile
Composite
Default screen
Using a multi-handset system
New Call tone
When you are on an intercom call and an
outside call comes in, you will hear New Call
tone over your conversation to tell you that
someone is calling you.
To answer the outside call and end the
intercom call:
Press the R button briefly
OR, to answer the outside call and put the
intercom call on hold (so you can later use
shuttle, conference or transfer):
Press the Ø/INT button for one second
To page all
To make all registered handsets ring (this is
handsets
useful if you've forgotten where you put a
from the
handset):
base unit
Press the HANDSET LOCATOR button on
the base unit
Handsets ring for up to 30 seconds. To stop the
ringing before this time:
Press the HANDSET LOCATOR button again
OR press any button on any handset
20
E:\Binatone2004\Lifestyle\Lifestyle_100\Lifestyle-100_UK_01.vp
14 April 2004 15:14:07
To register a
The handset supplied with your base unit should not
new handset
need to be registered; only additional ones you have
to your base
bought separately.
unit
Each handset can be registered to up to four base
units, numbered 1 to 4.
1
Press and hold the HANDSET LOCATOR
button on the base unit until you hear
Registration tone (slow 'beeps')
You now have 30 seconds in which to register
the handset.
2
On the handset, press the PROG button
then key in 1 6 followed by the base unit
number
If this is the first base unit you're registering to,
its number is 1.
3
Key in 0000 (the base unit's PIN
code)
4
Press the PHONE/OK button
The display shows the handset numbers which
are still free on the base unit.
5
(Optional) Key in a handset number
If you don't key in a number at this point, the
handset will be registered with the lowest free
number.
The handset beeps to confirm registration.
Binatone Help Line: 0845 345 9677
(Local Call rate)
Using a multi-handset system
21
Advertisement
Table of Contents
