Electrolux EWC 1350 User Manual page 9

SELECT THE REQUIRED PROGRAMME
BY MEANS OF THE PROGRAMME
SELECTOR DIAL (9)
Turn the programme selector dial to the re-
quired programme. The selector can be
turned either clockwise or anticlockwise.
The green light of button 6 starts to flash
On programme progress display the pilot
lights corresponding to all phases compos-
ing the selected programme are lit.
On position the programme is reset and
the machine is switched OFF.
At the end of the programme the selec-
tor dial must be turned to position
switch the machine off.
Important! If you turn the programme
selector dial to another programme when
the machine is working, the lights in the
programme progress display will start to
flash to indicate a wrong selection. The
machine will not perform the new selected
programme.
SELECT THE SPIN SPEED, RINSE
HOLD OR NO SPIN OPTION (8)
Select the spin speed, Rinse Hold option or
No Spin option by turning the spin speed
selector.
• The position 1300 (or 1000) is equivalent
to 900 rpm for the synthetic and wool
programmes and 700 rpm for the deli-
cate wash programme.
• The position 500 is equivalent to 500 rpm
for the synthetic and wool programmes
and 450 rpm for the delicate wash pro-
gramme.
Rinse hold
By selecting this option the water of the last
rinse is not emptied out to prevent the fab-
rics from creasing. When the programme
has finished, the lights "End" and "Door
locked" are lit to indicate that the water
must be emptied out (See: " At the end of
the programme").
No spin
By selecting this option all the spinning
phases are excluded. To be used for ex-
tremely delicate material. The machine will
add some additional rinses to the cotton
and synthetic programmes.
For the maximum spin speed allowed by
each programme, refer to the chapter
Washing programmes.
SELECT THE DELAY START BY
PRESSING BUTTON 2
Before you start the programme, if you wish
to delay the start, press the button 2 re-
peatedly, to select the desired delay. The
light corresponding to the set delay lights
up.
to
You must select this option after you have
set the programme and before you press
button Start.
You can cancel or modify the delay time at
any moment, before you press button
Start.
Cancelling the delayed start after having
pressed button Start:
1. Set the washing machine to PAUSE by
pressing button Start.
2. Press the button 2 once, the light rele-
vant to the selected delay goes off.
3. Press button Start again to start the
programme.
electrolux 9