Electrolux EWC 1350 User Manual page 10

10 electrolux
Important! The selected delay can be
changed only after selecting the washing
programme again.
The door will be locked throughout the de-
lay time (door locked light lit).
The Delay Start can not be selected with
DRAIN or SPIN programme.
SELECT THE DESIRED OPTION BY
MEANS OF BUTTONS 3, 4 AND 5
Depending on the programme, different
functions can be combined. These must be
selected after choosing the desired pro-
gramme and before pressing the button
6.The relevant light will illuminate.
If an incorrect option is selected, the corre-
sponding indicator lamp flashes for about 2
seconds. For the compatibility of the op-
tions with the washing programmes, refer
to the chapter «Washing programmes».
START THE PROGRAMME BY
PRESSING BUTTON 6
To start the selected programme, press this
button; the corresponding pilot light stops
flashing and remains lit.
On programme progress display the pilot
lights A and E illuminate to indicate that the
appliance starts operating and the door is
locked.
ALTERING AN OPTION OR A RUNNING
PROGRAMME
It is possible to change any option before
the programme carries it out.
Before you make any change, you must
pause the washing machine by pressing the
button 6.
The programme can be changed as long as
the button 6 has not been pressed. Chang-
ing a running programme is possible only
by resetting it. Turn the programme selector
dial to and then to the new programme
position. Start the new programme by
pressing the button 6 again.
INTERRUPTING A PROGRAMME
Press the button Start\Pause to interrupt a
programme which is running, the corre-
sponding light starts to flash. Press the but-
ton again to restart the programme.
CANCELLING A PROGRAMME
Turn the selector dial to
cel a programme which is running. Now
you can select a new programme.
OPENING THE DOOR AFTER THE
PROGRAMME HAS STARTED
First set the machine to pause by pressing
the button 6.
After some minutes, the door can be
opened, when the following conditions are
observed:
• The water temperature is below 55°C.
• The water level is below the bottom edge
of the door.
• The machine doesn't spin.
If you cannot open the door but it is abso-
lutely necessary to open it you have to
switch the machine off by turning the selec-
tor dial to . After few minutes the door
can be opened
(Pay attention to the water level and
temperature!).
After this procedure, it will be necessary to
set the programme and the options again
and then press the button 6.
AT THE END OF THE PROGRAMME
The machine stops automatically.
The pilot light D illuminates to indicate that
the programme has finished. The pilot light
E goes out, the door can be opened and
the laundry can be removed.
If at the end of a programme there is water
in the tub (when "Rinse hold" option has
been selected), to empty out the water
follow the following instructions:
• turn the programme selector dial to
• select the «Drain» or «Spin» programme
• press button 6
When the pilot light E goes out, the door
can be opened and the laundry can be re-
moved.
position to can-