Advertisement
5. Remove the necessary End Plug Pipes so that the End Pipes of the panels may be connected together.
Only 2 End Pipe Plugs remain in place.
6. Insert only one Water Baffle in the center of the End Pipes at the filter hook-up side of the panel system.
(There should be an equal number of panels on each side.) Only one Water Baffle is used in the entire
system. It is inserted into the female side of the End Pipe before the panels are joined.
The correct location of the Water Baffle directs the flow of water through the panels and placing the
Water Baffle in the correct location is very important. Failure to use a Water Baffle or placing it in the
wrong location will greatly reduce the heating ability of the ecoSAVER system. (see Diagram C-1)
7. Twist-connect all of the panels together. Make sure the support collar stays in place on the female End
Pipe fitting.
Refer to points 10. through 17 on pages 6 and 7.
8. Hook up the filter hose to one side of the panel and pool hose to the other side as described above and
the system is ready to use. Special Note: If you are installing 3 (or more) panel systems only one Water
Baffle is used. It will be located in the center of the system with an equal number of half panels on each
side of it. All other Water Baffles must be REMOVED. Additional End Plugs will also need to be removed
to connect all panels together.
Refer to Use and Maintenance (page 10) and the
9.
Optional Diverter Valve Kit (part # ESDK-1) Installation (page 12)
Remove End Pipe Plugs as necessary
9
Advertisement
