Advertisement
Make sure the "O" Rings are in place on the male ends of both the Valve and the Spacer. Make sure the
support collar stays in place on the female End Pipe fitting. Insert and twist-connect the Valve and the Spacer
into the 2 panels. You are now ready to control the flow of water through the many small tubes of the
ecoSAVER system. (see Diagram D (b))
8. On a Single 10' System: The Diverter Valve and the Panel Spacer are installed between the 2 panels. When
installing a Diverter Valve and Panel Spacer on a 10' system NO Water Baffle is installed. Place the Diverter
Valve between the panels at the side where the filter and pool hoses connect. Place the Panel Spacer
between the panels at the opposite side. Make sure the "O" Rings are in place on the male ends of both the
Valve and the Spacer. Make sure the support collar stays in place on the female End Pipe fitting. Insert and
twist-connect the Valve and the Spacer into the 2 panels. (see Diagram D (b))
9. On a Double 10' System: The Diverter Valve and the Panel Spacer are placed in the middle of the system
with an equal number of panels on either side. Do NOT install a Water Baffle. Twist-connect all panels
together as described above. (see Diagram D (c ))
1. Separate
Panels
3. Insert
Panel
Spacer
Diagram D (a)
(1) 20' System Diverter Valve Kit Installation
2. Separate
Panels
and
REMOVE
Water Baffle
4. Insert
Diverter
Valve
13
Advertisement
