Advertisement
End Pipe Plug
Open Ends
End Pipe Plug
1. If you purchased an ecoSAVER system with 10' long panels, 2 Panel Assemblies come in the box.
2. Carefully remove the panel from the box. Each Panel Assembly is made up of 2 half panels attached
together at the factory
3. Remove the strap and unroll the 2 Panel Assemblies. Allow it to sit in the sun so that it will become more
flexible.
4. While the panel relaxes remove the hardware kit from the box and count all pieces to make sure they are
all there. (See picture of Hardware Kit and Parts List Page 4)
5. Lay the 2 Panel Assemblies next to each other. The 10' panels arrive with End Pipe Plugs in the required
locations for easy assembly. Make sure the open ends (i.e. non-plugged ends) of the End Pipes face each
other. (see Diagram A-1).
6. An open male End Pipe Connection must face an open female End Pipe Connection on both sides of the
Panel Assemblies.
7. An "O" Ring comes factory-installed on both male end pipe fittings. Check to make sure the "O" Rings are
in place. If not, you will need to install them. A support collar comes on the female End Pipe fitting.
Check to make sure it is in place.
INSTALLING (1) 10' ecoSAVER SYSTEM
Diagram A-1
Connecting (2) 10' Panel Assemblies
Male Twist-Connect Elbow
with Hose Adapter
Water Flow
Open Ends
Insert Water
Baffle
Water Flow
Female Twist-Connect Elbow
with Hose Adapter
5
Advertisement
