Advertisement
8. Before attaching the panels together, it will be necessary to install a Water Baffle to direct the proper
flow of water through the panels. The Water Baffle is in the hardware kit. It is a white plastic disc that
directs the water through the small tubes. The Water Baffle is inserted into the female side of the End
Pipe before the 2 Panel Assemblies are joined. The correct location of the Water Baffle controls the flow
of water through the panels and placing the Water Baffle in the correct location is very important.
Failure to use a Water Baffle or placing it in the wrong location will greatly reduce the heating ability of
the ecoSAVER system.
9. One Water Baffle is inserted in the End Pipe Connection between the 2 Panel Assemblies at the same side
as the hose hook ups for the filter and the pool. (see Diagram A-1)
10. After installing the Water Baffle, insert the male End Pipe Connection into the female End Pipe
Connection and twist to attach the 2 Panel Assemblies together. Repeat this process at both sides of the
Panel Assemblies. Make sure the support collar stays in place on the female End Pipe fitting.
10' Panel Assembly - Male Twist-Connect Elbow connects to Female End Pipe Connection
Ensure
"O" Rng
is in place
11. There is a male and female Twist-Connect Elbow. Check to make sure the "O" Rings are in place on the
male side of the End Pipe and the male Twist-Connect Elbow. (see Diagram B1 and B2)
Attach both Twist-Connect Elbows to the proper sides of the End Pipe.
Ensure "O" Rng
is in place
Ensure "O" Rng
is in place
B1: Male Twist-Connect Elbow connects to Female End Pipe Connection
B2: Female Twist-Connect Elbow connects over Male End Pipe Connection
6
Advertisement
