Monitor Settings Pane: Identify Monitor; Add Device - Blackmagicdesign SmartView Installation And Operation Manual

Getting Started
21
You can manually add a SmartView, by IP address, to the list of
SmartView Monitors

Monitor Settings Pane: Identify monitor

Enable this setting to display a white border on the selected SmartView monitor. If you have several
SmartView units on a network, this setting makes it easy to identify the selected monitor. The white border
will appear both on the LCD monitor and in the Blackmagic SmartView Utility software interface.
If this setting is used with SmartView Duo in conjunction with the "Adjust both monitors together" setting,
the white border will be displayed on both monitors.
You can use Blackmagic SmartView Utility to enable or disable the "Identify monitor" setting when
connected to SmartView hardware via Ethernet or USB.
A white border will appear around the selected LCD monitor(s) when the "Identify monitor" feature is enabled.

Add Device

If you already know the IP address of a SmartView but it hasn't automatically appeared in the SmartView
Monitors pane, you can add the SmartView manually. To do so, go to the
or alternatively click Add Device (+) at the bottom of the SmartView Monitors pane. Type in the IP
Device
address of the SmartView monitor and click
and add it to the SmartView Monitors list. If the Blackmagic SmartView Utility does not find a SmartView at
the specified address, it will not add the unit to the list and will instead present a warning, "A SmartView
Monitor could not be found."
You can use Blackmagic SmartView Utility to manually add a SmartView when connected to SmartView
hardware via Ethernet or USB.
Device
. The software will verify the presence of the SmartView unit
OK
menu and choose
Add