Table of Contents
Advertisement
Using Blackmagic SmartView Setup
Updating the Software
Once Blackmagic SmartView setup is installed and launched, click on the settings icon below
the name of your monitor. You may be prompted to update the internal software of your
SmartView or SmartScope. To do so:
1
Connect your SmartView or SmartScope to the computer via USB or Ethernet and
launch Blackmagic SmartView setup.
2
When prompted, simply click update. The update may take about 5 minutes
to complete.
3
The message: "This SmartView has been updated" should appear upon completion
of the update.
4
Click close.
If no internal software update is required, Blackmagic SmartView setup will open the settings
page for your monitor.
When launching SmartView setup and opening the settings icon
for your connected SmartView or SmartScope, this message will
appear if an internal software update is required
The update will take about 5 minutes to complete
Adjusting Monitor Settings
When launched, Blackmagic SmartView setup will immediately search for any SmartView or
SmartScope units connected via USB or Ethernet and display them in the SmartView setup
home page. If you have more than one Blackmagic monitor connected to your network, click on
the left and right arrow icons on each side of the home page to select the monitor you want to
adjust. If your Blackmagic monitor is connected via USB, a USB icon will appear next to the
monitor name.
To adjust settings, select your monitor connected via Ethernet and USB, and click on the
settings icon below the monitor name. This will open the settings page for your selected
monitor. When you are happy with your settings, click the save button to save your settings
and return to the SmartView setup home page.
Using Blackmagic SmartView Setup
7
Hide quick links:
Advertisement
Table of Contents
