Sound Confirmations - iSmartAlarm Home Security System Owner's Manual

2. Replace the button battery with same type - CR2032.
3. LED flashes red once when the battery is installed.
NOTE: Whenever removing and/or replacing batteries, you should wait
at least ten seconds before placing new batteries in the device. This
will allow the device residual power charge to cycle through.
LED statuses of contact sensors, motion sensors and
remote tags
1. Device is powered on: red LED flashes once.
2. Device has been successfully added to a network: red LED flashes
twice.
3. Device is working normally: red LED is off.
4. Device has been triggered: red LED flashes once.
5. Low battery: red LED flashes 3 times for every 3 seconds.

SOUND CONFIRMATIONS

1. Siren stays on when the system is set off or the Siren button is
clicked twice (in quick succession) on either App or a Remote Tag.
2. Arm/Home: 1 "beep" confirmation.
3. Disarm: 2 "beep" confirmations.
7