Technical Specifications - HP ProLiant ML115 G5 Quickspecs

QuickSpecs

Technical Specifications

System Unit System Unit System Unit System Unit Dimensions Dimensions Dimensions Dimensions
(HxWxD)
(with feet)
Weight (approximate) Weight Weight Weight
Input Requirements Input Requirements Input Requirements Input Requirements
(per power supply)
BTU Rating BTU Rating BTU Rating BTU Rating
Power Specifications Power Specifications Power Specifications Power Specifications
Power Supply Output Power Supply Output Power Supply Output Power Supply Output
(per power supply)
System Inlet Temperature Operating System Inlet Temperature System Inlet Temperature System Inlet Temperature
Altitude Altitude Altitude Altitude
DA - 13013 Worldwide — Version 2 — April 4, 2008
14.5 x 6.9 x 16.8 in (36.7x 17.5 x 42.6 cm)
Maximum
(all hard drives, power
supplies, and processors
installed)
Minimum
(one hard drive, power
supply, and processor
installed)
Rated Line Voltage
Rated Input Current
Rated Input Frequency
Rated Input Power
Maximum
To review typical system power ratings use the Power Calculator which is
available via the online tool located at URL:
http://h30099.www3.hp.com/configurator/calc/Power%20
Calculator%20Catalog.xls
Rated Steady-State Power 365 W (at 100 VAC),
Maximum Peak Power
Non-operating
Operating
Non-operating
HP ProLiant ML115 Generation 5 HP ProLiant ML115 Generation 5 HP ProLiant ML115 Generation 5 HP ProLiant ML115 Generation 5
31.35 lb (14.22 kg)
25.75 lb (11.68 kg)
90 –- 132 VAC,
180 – 264 VAC
6 A (at 110 VAC),
3 A (at 200 VAC)
47 to 63 Hz
365 W (at 100 VAC),
365 W (at 200 VAC)
1885 BTU/hr (at 100 VAC),
U/hr (at 200 VAC)
365 W (at 200 VAC)
385 W (at 100 VAC),
385 W (at 200 VAC
10° to 35°C (50° to 95°F) at sea level with an
altitude derating of 1.0°C per every 305 m
(1.8°F per every 1000 ft) above sea level to a
maximum of 3050 m (10,000 ft), no direct
sustained sunlight. Maximum rate of change is
10°C/hr (18°F/hr). The upper limit may be
limited by the type and number of options
installed.
System performance may be reduced if operating
with a fan fault or above 30°C (86°F).
10 to 90% relative humidity (Rh), 28°C
5 to 95% relative humidity (Rh), 38.7°C
3050 m (10,000 ft). This value may be limited by
the type and number of options installed.
Maximum allowable altitude change rate is 457
m/min (1500 ft/min).
9144 m (30,000 ft). Maximum allowable
altitude change rate is 457 m/min (1500 ft/min).
Page 23