Advertisement
CANISTER CARE
For best cleaning results, the dust bag
should be changed often, The electronic
performance
indicator will come on when
the bag needs to be changed or the airflow
is blocked
NOTE: See PARTS AND FEATURES
for
Bag Number,
4. Disengage
cardboard
tab from
red bag mount by
pulling away and
lifting up
5. Pull bag out of
the red bag mount.
1. Unplug cord
from wail outlet.
2. Remove hose
from canister.
3, Pull hood
release out and up,
then lift canister
hood,
Safety
Filte
Red Bag
Mount
6. Check the
motor safety
filter and
replace, if
necessary
7. The red bag mount will flip forward after
removing bag. This will prevent the hood
from closing until a new bag is installed
1. Unplug cord from wall outlet, DO NOT
drip water on vacuum
cleaner.
Note:
DO NOT bend or crease the middle
of the cardboard
when installing the bag
into the bag mount
slots.
8. Rotate red bag
mount down and
install bag into slots
per illustration,
pushing down until
the cardboard
tab
locks into position
and the holes align.
Tuck the bag
securely into the bag cavity so that none of it
is able to be pinched by the hood,
9. Close and latch canister hood_
10. Reinstall hose
!1. Plug cord into wall outlet.
i ,i i, ,111,1111
ii
i
i
CAUTION
NEVER REUSE A DUST BAG. Very fine
materials,
such as carpet freshener,
face powder, fine dust, plaster,
soot,
new carpet
lint, etc. can clog the bag
and cause
it to burst before
it is full and
may cause damage
to vacuum
cleaner
motor.
Change
bag more often when
vacuuming
these materials.
2o Clean exterior using a clean, soft cloth
that has been dipped in a solution of mild
liquid detergent
and water, then wrung dry.
Wipe dry after cleaning.
3_ To reduce static electricity
and dust build-
up, wipe outer surface of vacuum cleaner
and attachments.
i
CAUTION
Do not use attachments
if they are wet.
Attachments
used in dirty areas, such
as under a refrigerator,
should
not be
used on other
surfaces
until they are
washed.They
could leave marks.
15
Advertisement
