Table of Contents
Advertisement
Connect the shower fittings
1.
Install the shower fittings (refer to the manufacturer's instructions).
2.
Connect the shower fittings to the mixer.
finish the Installation
.
Make sure that the mixer knobs are in the off position.
2.
Turn on the hot and cold water supplies and check for leaks from both the mixer
and the drain.
3.
use the special key (provided) to unscrew and remove the aerator.
4.
Turn on the hot and cold knobs and allow the water to run for approximatley
one minute to remove any debris.
5.
Turn the hot and cold knobs to the off position and re-install the aerator using
the special key.
Operation
set the temperature by slowly turning the temperature selector (right handle).
for safety reasons there is a stop that limits the tempeature to 38°c. To get a higher
temperature, push the button and contiue turning the temperature selector
Shower
Aerator
Tool
5
08774-W2-A
Advertisement
Table of Contents
