Lighting Bulb Exchange Procedure; Electrical Connections - Quickie Jive Instructions For Use Manual

14.4.2 cleaning controls
Should the control of your wheelchair become soiled
or dirty, it can be wiped with a damp cloth with a dilute
disinfectant until clean.
warnIng!
This is important should the wheelchair be used by more
than one person to ensure there is no cross infection.
Speciality controls
warnIng!
Ensure that wafer boards, joysticks (all variants), head
arrays and switches (all variants) are cleaned with a
mild disinfectant and a cleaning cloth to avoid any cross
infection possibilities. Following removal from chair
regularly wash the sip and puff mouth piece and tube to
maintain cleanliness and functionality.
warnIng!
Ensure control is switched off before cleaning.

14.5 lighting bulb exchange procedure

If the bulbs of your lights and indicator system show a
defect, indicated through a double speed flash of the
indicating LED on the hand control, please proceed in
the following way:
front and rear lights, (bulb) :
(Refer to Fig.14.18 - 14.20).
• Use a flat bladed screwdriver to gently lever off the
plastic cover.
• Lift the cover away carefully.
• Use a cross blade jewellers screwdriver to undo the
small lamp cover screw.
• Carefully lift the lamp cover off. Take care not to
loose the screw.
• The lamp is a 5W - 12v, 90
• The lamp, lamp cover and screw.
front and rear lights, (led):
For the LED lights and indicators, specific 12V clusters
using an E12 thread are required.
Please contact your approved Sunrise Medical dealer for
spares.
note: Use Sunrise Medical authorised spare parts only.
Be advised that all lighting circuits are electronically
protect ed. In the event of a short circuit current will be
limited to a safe level. Once the fault is removed the
system resets automatically.
52
Quickie Jive
° bayonet fit.
Fig. 14.18
Fig. 14.19
Fig. 14.20

14.6 electrical connections

When inspecting electrical connections, pay attention to
the battery connections, the connection of batteries to
power loom and plug in sockets for the joystick, control
box and lights and indicators.