Leg Rests - Quickie Jive Instructions For Use Manual

5.7.4 adjusting armrest height
Please refer to your appropriate armrest type.
Single Post Arm Rest (Comfort, Rehab and Recaro Seat):
The height adjustment of the armrests is made via the
threaded screws at the forward edge of the stanchion
tube . To adjust the height, (Fig. 5.11) loosen the adjusting
screws (3.0 mm Allen Key), move the armrest to the desir-
ed position and tighten the screw.
Reclining arm rest, (Fig.5.12):
• Loosen the screw at the rear armrest receiver.
• Slide the armrest extrusion up or down inside the slot
in the backrest frame.
• Tighten the screw at the appropriate height.
• Loosen the set screw on the front post.
• Adjust the front height.
• Tighten all screws.
• Repeat for the other side.
Fig.5.11

5.8 leg rests

warnIng!
• Be aware of your environment to make sure you do
not injure your legs when Leg Rests are extended.
• Always ensure that the Leg Rests or foot plates do
not come into contact with the castors before driving
the wheelchair.
• Leg Rests are not to be used for lifting or carrying the
wheelchair under any circumstances.
• As with all moving parts be careful not to trap your
fingers.
5.8.1 leg rest removal
To swing away the leg rest:
• Depress the retaining catch and swing the leg rest
out, (Fig.5.13).
• Lift the leg rest up and off if removal is required,
(Fig.5.14).
To refit:
• Line up the holes and studs, (Fig.5.15).
• Drop the leg rest into the receiver.
• Push the leg rest inwards until it clicks shut,
(Fig.5.16).
To adjust the angle: (Fig 5.17-5.18).
• Use a 5.0mm Allen key and 13.0mm spanner to
loosen stud A,
• Remove stud B.
• Tilt the receiver until the required hole lines up with
the top hole.
• Refit the stud.
20
Quickie Jive
Fig.5.12
Fig.5.13
Fig.5.15
A B
70°
75°
80°
Fig.5.17
5.8.2 foot plates
The foot plates may be flipped up to aid entry and exit
from the chair.
warnIng!
Do not use the foot plates to stand on as the full weight of
your body may cause the chair to tip forwards. This could
result in injury and could damage the foot rests.
5.8.3 adjusting the foot rest length
To adjust the foot rest length remove the bolts/screws on
the foot rest stem as shown in (Fig. 5.19, 70° and 5.20,
Centre Mount), adjust the length to suit. Ensure the bolts/
screws are firmly located and tighten ed prior to use.
note: The internal foot rest stem may require cutting
down in length to allow the foot plate position to be
raised.
Fig.5.19
Fig.5.14
Fig.5.16
Fig.5.18
Fig.5.20