Vr2-L - Quickie Jive Instructions For Use Manual

7.10 vr2-l

There are common controls between the VR2 and the
VR2-L control systems where a control differs it will be
described below. All common controls can be found on
the previous page.
Lights and indicators:
The wheelchair can be equipped with lights and
indicators. Where lights are not factory fitted, they may
be fitted as an optional extra by an approved Sunrise
Medical authorised dealer.
warnIng!
Ensure that the lights and indicators are functioning
correctly and lenses are clean before going outdoors at
night.
Indicators:
To turn on the wheelchairs indicators operate the
required button either left or right, the associated LED
will also illuminate continuously.
If the LED flashes rapidly either a total short circuit, a
single lamp open circuit or a total open circuit in the left
or right indicator circuit has been detected.
Depress the indicator button to turn off the indicator and
the associated LED.
main lights:
To turn on the wheelchairs lights operate this button, the
associated LED will illuminate continuously.
If the LED flashes a short circuit in the lighting circuit has
been detected.
Depress the light button to turn off the lights and the
associated LED.
Hazard warning lights:
To turn on the wheelchairs hazard warning lights operate
this button, the associated LED will flash at the same
rate. The left and right turn indicator LEDs will also flash.
If the LED flashes rapidly either a total short circuit, a
single lamp open circuit or a total open circuit in the
entire indicator circuit has been detected.
Depress the hazard warning button to turn off the lights
and the associated LED.
Actuator button and LEDs:
Depending on whether your wheelchair is fitted with one
or two actuators the operation of this button will differ.
28
Quickie Jive
wheelchairs with one actuator
Depressing the actuator button will enter actuator
adjustment mode. This will be indicated by the
illumination of both actuator LED's. Actuator adjustment
can then be made by deflecting the joystick forwards
or backwards. To re-enter drive mode, depress either
actuator button.
wheelchairs with two actuators
Depressing the actuator button will enter actuator
adjustment mode. Depressing the button once illuminates
the left LED, and deflection of the joystick will adjust
the actuator motor connected to that channel. If the
right button is depressed the associated LED will be
illuminated, and deflection of the joystick will adjust the
actuator motor connected to the other channel.
To re-enter drive mode, depress the selected actuator
button, as indicated by the associated LED.
It is also possible to select the other actuator by left or
right movements of the joystick.
hazard
lIghts
lIghts
actuator
button
IndIcators
actuator
led's
fig. 7.2