Quickie Jive Instructions For Use Manual page 31

self help guide, (fig.8.1).
If a system trip occurs you can find out what has happened by counting the number of LED's on the battery gauge that
are flashing.
Go to the number on the list which matches the number of flashing bars and follow the instructions.
Slow or sluggish movement - If the wheelchair does not travel at full speed or does not respond quickly enough and the
battery condition is good, check the maximum speed setting. If adjusting the speed setting does not remedy the problem
then there may be a non hazardous fault. Consult your Sunrise Medical authorised dealer.
speed/profile Indicator ripples up and down - This indicates the control system is locked, refer to section 7.3 for
details on how to unlock the control system.
speed/profile Indicator flashes - This indicates that the speed of the wheelchair is being limited for safety reasons.
The exact cause will depend on the build of the chair but usually indicates that the seat is elevated.
actuator led flashes - This indicates that the actuators may be inhibited in one or both directions.
fault code flash possIble cause
10
10 + S
10 + A
The batteries need charging, or there is a bad connection to the battery. Check the
1
connections to the battery. If the connections are good, try charging the batteries.
The left hand motor has a bad connection. Check the connections to the left hand
2 motor.
The left hand motor has a short circuit to a battery connection. Contact your Sunrise
Medical authorised dealer.
3
The right hand motor has a bad connection. Check the connections to the right hand
4 motor.
The right hand motor has a short circuit to a battery connection. Contact your Sunrise
5 Medical authorised dealer.
The wheelchair is being prevented from driving by an external signal. One possibility
6 is that the battery charger is plugged in.
A joystick fault is indicated. Make sure that the joystick is in the centre position before
switching on the control system.
7
A control system fault is indicated. Make sure the control system connections are
8 secure.
The parking brakes have a bad connection. Check the parking brake and the motor
9 connections. Make sure that the control system connections are secure.
An excessive voltage has been applied to the control system. This is usually caused
by a poor battery connection. Check the battery connections
S = Speed indicator LED's
A communication fault is indicated. Make sure that the joystick cable is securely
connected and not damaged.
A = Actuator LED's
An actuator trip is indicated. If more than one actuator is fitted, check which actuator
is not working. Check the actuator wiring.
31
Quickie Jive