Care Of Glass And Plated Parts; Venting; Dimensions; Venting Lengths And Air Terminal Locations - Napoleon Torch GT8N Installation And Operation Instructions Manual

Vented gas fireplace

Hide thumbs Also See for Torch GT8N:

Installation and operating instructions manual (88 pages)

Installation and operation manual (84 pages)

Installation and operation instructions manual (16 pages)

Table Of Contents

Table of Contents

The glass is 3/16" ceramic

glass, available from your

Napoleon® / Wolf Steel Ltd.

dealer. Clean the glass after

the ﬁ rst 10 hours of operation

with a recommended gas

ﬁ replace glass cleaner. Thereafter clean as required. DO NOT CLEAN GLASS

WHEN HOT! Do not use abrasive cleaners to clean plated parts. Buff lightly

with a clean dry cloth. If the glass is not kept clean permanent discolouration

and / or blemishes may result.

ELECTRICAL

ACCESS

The vent connection to the ﬁ replace can be viewed by removing the bafﬂ e from the top, inside of the ﬁ rebox.

Use only Wolf Steel venting components. Minimum and maximum vent lengths, for both horizontal and vertical installations,

and air terminal locations for either system are set out in this manual and must be adhered to. Use only Wolf Steel Ltd.

ﬂ exible vent components with the Wolf Steel Ltd. GD179 termination kit. This ﬁ replace uses a 3" exhaust and a 5"

instake diameter coaxil vent system.

All outer pipe joints of these venting systems must be sealed using Red RTV and/or Mill Pac high temperature sealant (not

supplied) hereafter referred to as high temperature sealant W573-0002 (Red RTV) and the high temperature sealant W573-

0007 (Mill Pac).

For vent systems that provide seals on the inner exhaust ﬂ ue, only the outer air intake joints must be sealed using a red high

temperature silicone (RTV). This same sealant may be used on both the inner exhaust and outer intake vent pipe joints of all

other approved vent systems except for the exhaust vent pipe connection to the ﬁ replace ﬂ ue collar which must be sealed

using the black high temperature sealant Mill Pac.

With ﬂ exible venting, in conjunction with the GD178 wall terminal kit, use either the 5 foot vent kit GDT5 or the 10 foot vent

kit GDT10. These kits allow for extended horizontal venting of the ﬁ replace.

When using approved Wolf Steel venting components, use only the following termination kits: WALL TERMINAL KIT GD178,

or 1/12 TO 7/12 PITCH ROOF TERMINAL KIT GDT110, 8/12 TO 12/12 ROOF TERMINAL KIT GDT111, FLAT ROOF

TERMINAL KIT GDT112.

Rigid and ﬂ exible venting systems must not be combined. Wolf Steel and Simpson Dura-Vent venting systems must not

be combined.

Venting terminals shall not be recessed into a wall or siding.

For optimum ﬂ ame appearance and ﬁ replace performance, keep the vent length and number of elbows to a minimum.

The air terminal must remain unobstructed at all times. Examine the air terminal at least once a year to verify that it is

unobstructed and undamaged.

Provide adequate ventilation and combustion air. Provide adequate accessibility clearance for servicing and operating the ﬁ replace.

Never obstruct the front opening of the ﬁ replace.

NorthlineExpress.com