Epson Viewer P-2000 User Manual page 19

Charging the battery
After installing the battery, charge the battery using
the AC adapter.
Note:
The battery status is always displayed at the top right corner
of the LCD.
: Indicates sufficient battery power.
: Indicates moderate battery power.
: Indicates low battery power.
: Indicates battery power is running out. P-2000 is shut down
automatically. Charge the battery using the AC adapter.
: Indicates the AC adapter is connected to P-2000.
1. Make sure that the battery is installed.
c
Caution:
Do not connect the AC adapter when the battery is
not installed. Doing so may cause P-2000 to be
damaged.
2. Connect the AC adapter to P-2000 as shown below
and plug the other end into a power outlet.
The Charge lamp is on during charging. When the
battery is fully charged, the Charge lamp turns off. It
takes about 3 hours to fully charge the battery when
P-2000 is off. It takes more when you are operating it.
Note:
P-2000 stops charging, if the battery becomes hot when
operating it during charging. In that case, it starts charging
again when it cools down.
Removing the battery
1. Make sure that P-2000 is turned off.
13
Getting Started
2
2
2
2
2
2
2
2
2
2