Network Settings - SMART LightRaise 60wi User Manual

C H A P T E R 8
Remotely managing your interactive projector
Submenu setting
Lamp Mode
Auto Power Off
High Speed Fan
VGA1
HDMI
Composite
Emergency Alert
Alarm Message

Network settings

This menu allows you to use or not use Dynamic Host Control Protocol (DHCP) and to set the
network-related addresses and names when DHCP is not used.
Submenu setting
DHCP
IP Address
Subnet Mask
75 smarttech.com/kb/170295
Description
Adjusts lamp brightness to Standard or Economy. Standard
displays a high-quality, bright image. Economy increases the lamp
life by decreasing the brightness of the image.
Sets the length of the auto power off countdown timer between 1 and
240 minutes. The timer begins to count down when the projector no
longer receives a video signal. The timer finishes when the projector
enters Standby mode. Select 0 to turn off the timer.
Adjusts the speed of the projector's fan. Select Normal or High .
N O T E
Use the High setting when the projector's temperature is high or the
altitude is above 6000' (1800 m).
Assigns an alternative name to your VGA 1 input, which appears
when you select the VGA 1 input.
Assigns an alternative name to your HDMI input, which appears
when you select the HDMI input.
Assigns an alternative name to your Composite video input, which
appears when you select the Composite video input.
Turns the on-screen alert broadcast message on or off. When
enabled, this message displays over the current projected image.
Displays an on-screen emergency notification message (maximum
60 characters).
Description
Determines if the projector's IP address and other network settings
are dynamically assigned by a DHCP server or manually set.
On allows the network's DHCP server to assign a dynamic IP
l
address to the projector.
Off allows you to manually set the projector's IP address and
l
other network settings.
Displays or allows you to set the projector's IP address in values
between 0.0.0.0 and 255.255.255.255.
Displays or allows you to set the projector's subnet mask number in
values between 0.0.0.0 and 255.255.255.255.